Design, analysis and fabrication of the CPW resonator loaded by DGS and MEMS capacitors
Open Access
- 30 April 2021
- journal article
- research article
- Published by IOP Publishing in Journal of Micromechanics and Microengineering
- Vol. 31 (6) , 065004
Abstract
In this paper, an analytical method of resonant frequency, tuning range, the effective relative dielectric constant, and characteristic impedance is proposed, which is for coplanar waveguide (CPW) resonator loaded by defected ground structure (DGS) and micro-electromechanical systems (MEMS) capacitors. The analytical solution is achieved by an employing equivalent method. The resonant frequency, tuning range, and effective relative dielectric constant are obtained by the analytical solution. For verifying the effectiveness of the proposed method, a CPW tunable bandstop filter (BSF) with DGS and MEMS capacitors is designed, simulated, and fabricated, results show good effectiveness of the proposed analysis method. By changing the height of the MEMS beam with the actuation voltage, the designed BSF can switch the center frequency among three states (i.e. 18.5 GHz, 18.2 GHz, 17.5 GHz, respectively), and fractional bandwidth is changed as well (i.e. 37.8%, 45.6%, 49.5%, respectively).Keywords
Funding Information
- Fundamental Research Funds for the Central Universities (2019PTB-016)
This publication has 31 references indexed in Scilit:
- Ka-Band Tunable Filter Using Metamaterials and RF MEMS VaractorsJournal of Microelectromechanical Systems, 2015
- Coplanar-Waveguide Ultra-Wideband Bandpass Filter Based on Interdigital Structure2015
- A tunable band-stop filter using a metamaterial structure and MEMS bridges on a silicon substrateJournal of Micromechanics and Microengineering, 2012
- Microstrip dual-band bandstop filter of defected ground structure and stepped impedance resonatorsInternational Journal of Electronics, 2010
- Novel compact low-loss millimeter-wave filters using micromachined overlay and inverted overlay coplanar waveguide transmission lines with defected ground structuresJournal of Micromechanics and Microengineering, 2006
- A tunable bandstop filter via the capacitance change of micromachined switchesJournal of Micromechanics and Microengineering, 2006
- CPW band-stop filter using unloaded and loaded EBG structuresIEE Proceedings - Microwaves, Antennas and Propagation, 2005
- Intermodulation distortion and power handling in RF MEMS switches, varactors, and tunable filtersIEEE Transactions on Microwave Theory and Techniques, 2003
- Mechanical Modeling of MEMS Devices: Dynamic Analysis2003
- Frontmatter and Index2001