Dynamic Path Flow Estimation Using Automatic Vehicle Identification and Probe Vehicle Trajectory Data: A 3D Convolutional Neural Network Model
Open Access
- 5 February 2021
- journal article
- research article
- Published by Wiley in Journal of Advanced Transportation
- Vol. 2021, 1-15
Abstract
Dynamic path flows, referring to the number of vehicles that choose each path in a network over time, are generally estimated with the partial observations as the input. The automatic vehicle identification (AVI) system and probe vehicle trajectories are now popular and can provide rich and complementary trip information, but the data fusion was rarely explored. Therefore, in this paper, the dynamic path flow estimation is based on these two data sources and transformed into a feature learning problem. To fuse the two data sources belonging to different detection ways at the data level, the virtual AVI points, analogous to the real AVI points (turning movements at nodes with AVI detectors), are defined and selected to statically observe the dynamic movement of the probe vehicles. The corresponding selection principles and a programming model considering the distribution of real AVI points are first established. The selected virtual AVI points are used to construct the input tensor, and the turning movement-based observations from both the data sources can be extracted and fused. Then, a three-dimensional (3D) convolutional neural network (CNN) model is designed to exploit the hidden patterns from the tensor and establish the high-dimensional correlations with path flows. As the path flow labels commonly with noises, the bootstrapping method is adopted for model training and the corresponding relabeling principle is defined to purify the noisy labels. The entire model is extensively tested based on a realistic road network, and the results show that the designed CNN model with the presented data fusion method can perform well in training time and estimation accuracy. The robustness of a model to noisy labels is also improved through the bootstrapping method. The dynamic path flows estimated by the trained model can be applied to travel information provision, proactive route guidance, and signal control with high real-time requirements.Keywords
Funding Information
- National Key Research and Development Program of China (2019YFB1600202)
This publication has 15 references indexed in Scilit:
- Origin-Destination Estimation Using Probe Vehicle Trajectory and Link CountsJournal of Advanced Transportation, 2017
- Vehicle path reconstruction using automatic vehicle identification data: An integrated particle filter and path flow estimatorTransportation Research Part C: Emerging Technologies, 2015
- Classification in the Presence of Label Noise: A SurveyIEEE Transactions on Neural Networks and Learning Systems, 2013
- Trip matrix and path flow reconstruction and estimation based on plate scanning and link observationsTransportation Research Part B: Methodological, 2008
- Dynamic Origin-Destination Demand Estimation Using Turning Movement CountsTransportation Research Record: Journal of the Transportation Research Board, 2008
- Dynamic Origin–Destination Demand Estimation Using Automatic Vehicle Identification DataIEEE Transactions on Intelligent Transportation Systems, 2006
- Estimation and Prediction of Time-Dependent Origin-Destination Flows with a Stochastic Mapping to Path Flows and Link FlowsTransportation Science, 2002
- Uncoupled Method for Equilibrium-Based Linear Path Flow Estimator for Origin-Destination Trip MatricesTransportation Research Record: Journal of the Transportation Research Board, 2002
- Real‐Time OD Estimation Using Automatic Vehicle Identification and Traffic Count DataComputer-Aided Civil and Infrastructure Engineering, 2002
- Estimation of origin-destination matrices from link traffic counts on congested networksTransportation Research Part B: Methodological, 1992