Simulation, Fabrication, and Characterization of a Sensitive SU-8-Based Fabry-Pérot MOEMS Accelerometer
- 23 January 2019
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 37 (9) , 1893-1902
Abstract
This paper presents the design, fabrication, and characterization of a SU-8 four L-shaped beams optical MEMS (MOEMS) accelerometer based on a Fabry-Perot(FP) interferometer. An applied acceleration causes a displacement of the proof mass and changes the cavity of FP resonator. Fabrication process has been simplified such that only two photolithography steps are required and SU-8 is used for both the structural body and the sacrificial layer. To prevent the sacrificial layer from being exposed to UV light, a thin copper layer is coated by physical vapor deposition technique between the two SU-8 layers. The sensor chip consists of a proof mass which is suspended by four L-shaped springs. The movement of the proof mass in response to acceleration is detected by a FP cavity formed between the proof mass and the cleaved end of a single mode optical fiber. The fabricated sensor has a sensitivity of 12.5 μW/g and resonant frequency of 1872 Hz in the range of ±1g.Keywords
This publication has 28 references indexed in Scilit:
- Determining the physical properties of EpoClad negative photoresist for use in MEMS applicationsJournal of Micromechanics and Microengineering, 2011
- A MOEMS accelerometer based on photoelastic effectOptik, 2011
- A high-resolution fiber optic accelerometer based on intracavity phase-generated carrier (PGC) modulationMeasurement Science and Technology, 2010
- Microfabrication of an electromagnetic power relay using SU-8 based UV-LIGA technologyMicrosystem Technologies, 2004
- A novel fabrication method of embedded micro-channels by using SU-8 thick-film photoresistsSensors and Actuators A: Physical, 2003
- Evaluation of MEMS capacitive accelerometersIEEE Design & Test of Computers, 1999
- Application of MEMS technology in automotive sensors and actuatorsProceedings of the IEEE, 1998
- SU-8: a low-cost negative resist for MEMSJournal of Micromechanics and Microengineering, 1997
- Three-dimensional microfabrication with two-photon-absorbed photopolymerizationOptics Letters, 1997
- High-sensitivity fiber-optic accelerometerOptics Letters, 1989