Experimental investigation into the use of collar for reducing scouring around short abutments
- 26 August 2019
- journal article
- review article
- Published by Taylor & Francis in Ish Journal of Hydraulic Engineering
- Vol. 27 (sup1) , 616-632
Abstract
Scouring at bridge abutments undermines the stability of bridges. There are various methods to countermeasure the foundation of bridge abutments against scouring, but using a protective collar is one of the simplest methods. In this study, 60 tests were carried out experimentally under clear-water conditions. The maximum depth and time variation of local scour at vertical-wall, wing-wall and semi-circular short abutments were investigated. Experiments were conducted for uniform bed materials under four different flow intensities. Second, using collars of different sizes (as a ratio of abutment length) on various elevations of the bed (below, on, and top of the bed level), experiments were carried out again to investigate the effect of a collar on abutment scouring. Also, the effect of using partial collars was compared with full-collars for different abutment. Results showed that as the collar width increased, the scouring depth reduced suggesting that the width of collar was the most important factor for collar performance. The collar was more efficient in lower flow than in upper flow. The collar with 2.25 La in width situated under the bed elevation on the vertical wall and on streambed elevation on the wing-wall and semi-circular abutments reduced scour depth.Keywords
This publication has 22 references indexed in Scilit:
- Protective spur dike for scour mitigation of existing spur dikesJournal of Hydraulic Research, 2011
- Reduction of local scour around bridge pier groups using collarsInternational Journal of Sediment Research, 2010
- Constriction Effects in Clear-Water Scour at AbutmentsJournal of Hydraulic Engineering, 2009
- Scour protection of circular bridge piers with collars and slotsJournal of Hydraulic Research, 2009
- Flow Intensity Parameter in Pier Scour ExperimentsJournal of Hydraulic Engineering, 2007
- Temporal scour development at bridge abutments with a collarCanadian Journal of Civil Engineering, 2007
- Reduction of Local Scour in the Vicinity of Bridge Pier Groups Using Collars and RiprapJournal of Hydraulic Engineering, 2006
- Riprap Protection at Bridge PiersJournal of Hydraulic Engineering, 2001
- Reduction of Local Scour around Bridge Piers Using Slots and CollarsJournal of Hydraulic Engineering, 1999
- Local scour and flow measurements at bridge abutmentsJournal of Hydraulic Research, 1994