Hybrid Microtip-Based Thermal Anemometer With Harmonic Vernier Effect on Fiber-Optic End Face
- 4 December 2024
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 43 (6) , 2956-2962
Abstract
The fabrication of an ultra-compact, highly sensitive anemometer on a hundred-micron fiber end face poses a formidable challenge. Traditional thermal anemometers often sacrifice low power consumption and temperature control for enhanced range and sensitivity. To overcome these limitations, we introduce a microtip-based thermal anemometer seamlessly integrated with optical fiber ends. First, a SiO2 microtip was prepared by the discharge melting tapering technique. Subsequently, a polymer microtip doped with photothermal material was further grown on the SiO2 microtip by photoinduced polymerization. This dual-layer microtip structure forms a cascade of Fabry-Pérot interferometer (FPI) and increases the sensitivity by approximately 10.8 times based on vernier effect. Zr-PDI is a metal-organic framework (MOF) with a photothermal efficiency of 52.3%, which can reach 113°C under 1.96mW (808 nm) laser irradiation. Experimental results demonstrate that the sensor achieves the wind speed detection range of 0–20 m/s, with a maximum sensitivity of 7.36 nm/(m/s) in the range of 0–3 m/s. This low-power, ultra-compact sensor features highly sensitive, wide-range wind speed measurement capabilities.Keywords
Funding Information
- National Natural Science Foundation of China (62105278)
- Natural Science Foundation of Shandong Province (ZR2021QF139)
- Doctoral Initiation Fund of Yantai University (WL20B129)
- Handan Science and Technology Research and Development Program (23422304077)
- Natural Science Foundation of Handan University (XZ2022408)
- Hebei Key Laboratory of Optical Fiber Biosensing and Communication Devices (SZX2022010)
This publication has 32 references indexed in Scilit:
- A Fabry-Perot interferometer based on probe-embedded bubble for ultrasensitive strain measurementMeasurement, 2024
- Fiber‐Integrated Force Sensor using 3D Printed Spring‐Composed Fabry‐Perot Cavities with a High Precision Down to Tens of PiconewtonAdvanced Materials, 2023
- Metal-organic-framework-based materials as platforms for energy applicationsChem, 2023
- Surface plasmon resonance sensor composed of microstructured optical fibers for monitoring of external and internal environments in biological and environmental sensingResults in Physics, 2023
- Sensitivity-Enhanced Hot-Wire Anemometer by Using Cladding-Etched Fiber Bragg GratingPhotonic Sensors, 2023
- Development of the reciprocating airflow generator for wave power generator and study on the vertical axis turbine characteristics in reciprocating airflowElectrical Engineering in Japan, 2022
- A hot-wire flowmeter based on fiber Extrinsic Fabry–Pérot Interferometer with assistance of fiber Bragg gratingOptics Communications, 2021
- A Multifunctional Airflow Sensor Enabled by Optical Micro/nanofiberAdvanced Fiber Materials, 2021
- Temperature-compensated fiber-optic gas flow speed sensor based on the ‘Hot-wire’ principleOptik, 2021
- High‐Q Polymer Microcavities Integrated on a Multicore Fiber Facet for Vapor SensingAdvanced Optical Materials, 2019