Jia-Zheng Sun
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jia-Zheng Sun has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Lingxin Kong
Yantai University
2 shared publications Feng Zhang
School of Physics and Electronic Information, Yantai University, Yantai, China
1 shared publication- Kang Yang
Hebei Key Laboratory of Optical Fiber Biosensing and Communication Devices, Institute of Information Technology, Handan University, Handan, China
1 shared publication - Mingxing Liu
Optical Fiber Based Intelligent Sensing and Micromachines Laboratory, School of Physics and Electronic Information, Yantai University, Yantai, China
1 shared publication - Shi-Jun Li
Optical Fiber Based Intelligent Sensing and Micromachines Laboratory, School of Physics and Electronic Information, Yantai University, Yantai, China
1 shared publication Wen-Yu Yan
School of Physics and Electronic Information, Yantai University, Yantai, China
1 shared publication
Latest Publications
- 13 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 38 (2) , 101-104
Fiber-Optic Thorium Ion Sensor Based on the Breathing Effect of Metal-Organic Frameworks
This letter introduces a fiber-optic thorium ion (Th4+) sensor based on the breathing effect of a UiO-AZO thin film. The sensor integrates a Mach-Zehnder interferometer (MZI) with a surface plasmon resonance (SPR) sensing element for simultaneous measurements. Under visible (Vis) light, the MZI sensor exhibits a sensitivity to Th4+ of 0.315 nm/nM. Under ultraviolet (UV) light conditions, the sensitivity is 1.68 nm/nM, and the limit of detection (LOD) as low as 0.8 nM. SPR is excited by Au-TiO2 and senses temperature changes through PDMS, with a sensitivity reaching −1.23 nm/°C. The reversible adsorption and desorption of Th4+ are controlled by switching between Vis and UV light, which enables in-situ calibration.
- 13 October 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 38 (2) , 101-104
Fiber-Optic Thorium Ion Sensor Based on the Breathing Effect of Metal-Organic Frameworks
This letter introduces a fiber-optic thorium ion (Th4+) sensor based on the breathing effect of a UiO-AZO thin film. The sensor integrates a Mach-Zehnder interferometer (MZI) with a surface plasmon resonance (SPR) sensing element for simultaneous measurements. Under visible (Vis) light, the MZI sensor exhibits a sensitivity to Th4+ of 0.315 nm/nM. Under ultraviolet (UV) light conditions, the sensitivity is 1.68 nm/nM, and the limit of detection (LOD) as low as 0.8 nM. SPR is excited by Au-TiO2 and senses temperature changes through PDMS, with a sensitivity reaching −1.23 nm/°C. The reversible adsorption and desorption of Th4+ are controlled by switching between Vis and UV light, which enables in-situ calibration.
- 4 December 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 43 (6) , 2956-2962
Hybrid Microtip-Based Thermal Anemometer With Harmonic Vernier Effect on Fiber-Optic End Face
The fabrication of an ultra-compact, highly sensitive anemometer on a hundred-micron fiber end face poses a formidable challenge. Traditional thermal anemometers often sacrifice low power consumption and temperature control for enhanced range and sensitivity. To overcome these limitations, we introduce a microtip-based thermal anemometer seamlessly integrated with optical fiber ends. First, a SiO2 microtip was prepared by the discharge melting tapering technique. Subsequently, a polymer microtip doped with photothermal material was further grown on the SiO2 microtip by photoinduced polymerization. This dual-layer microtip structure forms a cascade of Fabry-Pérot interferometer (FPI) and increases the sensitivity by approximately 10.8 times based on vernier effect. Zr-PDI is a metal-organic framework (MOF) with a photothermal efficiency of 52.3%, which can reach 113°C under 1.96mW (808 nm) laser irradiation. Experimental results demonstrate that the sensor achieves the wind speed detection range of 0–20 m/s, with a maximum sensitivity of 7.36 nm/(m/s) in the range of 0–3 m/s. This low-power, ultra-compact sensor features highly sensitive, wide-range wind speed measurement capabilities.
- 4 December 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Lightwave Technology
- Vol. 43 (6) , 2956-2962
Hybrid Microtip-Based Thermal Anemometer With Harmonic Vernier Effect on Fiber-Optic End Face
The fabrication of an ultra-compact, highly sensitive anemometer on a hundred-micron fiber end face poses a formidable challenge. Traditional thermal anemometers often sacrifice low power consumption and temperature control for enhanced range and sensitivity. To overcome these limitations, we introduce a microtip-based thermal anemometer seamlessly integrated with optical fiber ends. First, a SiO2 microtip was prepared by the discharge melting tapering technique. Subsequently, a polymer microtip doped with photothermal material was further grown on the SiO2 microtip by photoinduced polymerization. This dual-layer microtip structure forms a cascade of Fabry-Pérot interferometer (FPI) and increases the sensitivity by approximately 10.8 times based on vernier effect. Zr-PDI is a metal-organic framework (MOF) with a photothermal efficiency of 52.3%, which can reach 113°C under 1.96mW (808 nm) laser irradiation. Experimental results demonstrate that the sensor achieves the wind speed detection range of 0–20 m/s, with a maximum sensitivity of 7.36 nm/(m/s) in the range of 0–3 m/s. This low-power, ultra-compact sensor features highly sensitive, wide-range wind speed measurement capabilities.