Parameter Optimization towards Highest Micro MIM Density by Using Taguchi Method
- 2 June 2010
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 443, 705-710
Abstract
Nowadays, micro metal injection molding has become among the promising method in powder metallurgy research to produce small-scale intricate part at an effective process and competitive cost for mass production. This paper investigated the optimization of highest green strength which plays an important characteristic in determining the successful of micro MIM. In this paper, stainless steel SS 316L with D50 = 5.96µm was used with composite binder, which consists of PEG (Polyethelena Glycol), PMMA (Polymethyl Methacrilate) and SA (Stearic Acid). Feedstock with 61.5% with several injection parameters were optimized which highly significant through screening experiment such as injection pressure(A), injection temperature(B), mold temperature(C), injection time(D) and holding time(E). Besides that, interaction effects between injection pressure, injection temperature and mold temperature were also considered to optimize in the Taguchi’s orthogonal array. Analysis of variance (ANOVA) in terms of signal-to-noise ratio (S/N-larger is better) for green density was also presented in this paper. Result shows that interaction between injection temperature and mold temperature(BxC) give highest significant factor followed by interaction between injection pressure and mold temperature(AxC). Single factor that also contributes to significant optimization are mold temperature(C) and injection time(D). This study shows that Taguchi method would be among the best method to solve the problem with minimum number of trials.Keywords
This publication has 8 references indexed in Scilit:
- Application of Taguchi optimization technique in determining plastic injection molding process parameters for a thin-shell partMaterials & Design (1980-2015), 2007
- Minimization of warpage and sink index in injection-molded thermoplastic parts using Taguchi optimization methodMaterials & Design (1980-2015), 2006
- Application of Taguchi method in the optimization of end milling parametersJournal of Materials Processing Technology, 2004
- Sintering study of 316L stainless steel metal injection molding parts using Taguchi method: final densityMaterials Science and Engineering: A, 2001
- The effective factors in the warpage problem of an injection-molded part with a thin shell featureJournal of Materials Processing Technology, 2001
- Application of Taguchi's method on the optimal process design of an injection molded PC/PBT automobile bumperComposite Structures, 1997
- Optimization of Part Wall Thicknesses to Reduce Warpage of Injection-Molded Parts Based on The Modified Complex MethodPolymer-Plastics Technology and Engineering, 1995
- An analysis of thermal warpage in injection molded flat parts due to unbalanced coolingPolymer Engineering & Science, 1982