First-Principles Study of the Effect of Sn Content on the Structural, Elastic, and Electronic Properties of Cu–Sn Alloys
Open Access
Abstract
In order to explore the mechanism of the influence of Sn contents on the relevant properties of Cu–Sn alloys, the structure, elasticity, electronic, and thermal properties of Cu–Sn alloys doped with different proportions of Sn (3.125 at%, 6.25 at%, and 9.375 at%) were established using the first-principles calculation based on density functional theory. Firstly, their lattice constants and Sn concentration comply with Vegard’s Law. From the mixing enthalpy, it can be seen that Sn atoms can be firmly dissolved in the Cu matrix, and the structure is most stable when the Sn content is 3.125 at%. In addition, the introduction of mismatch strain characterized their solid solution strengthening effect. The elastic and electronic properties showed that when the Sn content is 6.25 at%, the Cu–Sn alloy has the best plasticity and the highest elastic anisotropy; when the Sn content is 3.125 at%, the Cu–Sn alloy is the most stable and has stronger bulk and shear modulus, which was mainly due to a stronger Cu-Cu covalent bond. Finally, the Debye temperature, thermal conductivity, and melting point were calculated. It is estimated that the thermal conductivity of Cu–Sn alloy is relatively good when the Sn content is low.Keywords
Funding Information
- The National Natural Science Foundation of China (52205373)
This publication has 56 references indexed in Scilit:
- Measurements of mechanical properties of α-phase in Cu–Sn alloys by using instrumented nanoindentationJournal of Materials Research, 2011
- The Closest Elastic Tensor of Arbitrary Symmetry to an Elasticity Tensor of Lower SymmetryJournal of Elasticity, 2006
- Deformation Mechanism of Nanocrystalline Al-Fe Alloys by Analysis from Ab-Initio CalculationsMaterials Science Forum, 2006
- The lattice parameter of α-bronzes as a function of solute content: application to archaeological materialsMaterials Science and Engineering: A, 2005
- Population analysis of plane-wave electronic structure calculations of bulk materialsPhysical Review B, 1996
- Generalized Gradient Approximation Made SimplePhysical Review Letters, 1996
- Elastic constants versus melting temperature in metalsScripta Metallurgica, 1984
- Elastic Constants and Their MeasurementJournal of Applied Mechanics, 1975
- Lattice parameters, densities, expansion coefficients and perfection of structure of Cu and of Cu–In α phaseActa Crystallographica Section A, 1969
- Dynamical Theory of Crystal Latticesby M. Born and K. HuangActa Crystallographica, 1956