Physical and mechanical properties of wood plastic composites polystyrene-white oak wood flour
- 8 January 2013
- journal article
- research article
- Published by SAGE Publications in Journal of Composite Materials
- Vol. 48 (2) , 209-217
Abstract
This study examines the effect of particle size and wood flour content on the properties of polystyrene filled with white oak flour. Wood-plastic ratios 10:90, 30:70 and 50:50% (wt/wt) and particle size 40, 50, 65 and 100 mesh were used. Tensile, bending and impact bending strength as well as the melt flow index were evaluated. Additionally, composite density and water absorption capacity were also tested. Scanning electronic microscopy revealed good adhesion between wood particles and polystyrene. Results show that mechanical properties are strongly influenced by wood flour content and particle size. A reduction in tensile module, elongation and deflection were observed, however, the bending module was increased. Impact strength increased with particle size and content. Melt flow index values are reduced with the increasing amount of filler content while water absorption increases with the amount of wood particles.Keywords
This publication has 17 references indexed in Scilit:
- Effects of Water Absorption on Creep Behavior of Wood—Plastic CompositesJournal of Composite Materials, 2008
- Natural Fibers, Biopolymers, and Biocomposites2005
- Efeitos do tipo de poliestireno de alto impacto nas propriedades de compósitos termoplásticos com farinha de resíduo de madeiraPolímeros, 2004
- Effect of Ageing on the Mechanical Properties of Short Sisal Fibre Reinforced Polystyrene CompositesJournal of Thermoplastic Composite Materials, 2003
- Processability and Properties of a Wood Flour Filled PolypropyleneInternational Journal of Polymeric Materials and Polymeric Biomaterials, 1992
- Effect of Fiber Treatment on the Mechanical Properties of Hybrid Fiber Reinforced Polystyrene Composites: III. Use of Mica and Sawdust as Hybrid FiberJournal of Reinforced Plastics and Composites, 1991
- Effects of Coating Treatments on the Mechanical Behavior of Wood Fiber-Filled Polystyrene Composites. II. Use of Inorganic Salt/Polyvinyl Chloride and Isocyanate as Coating ComponentsJournal of Reinforced Plastics and Composites, 1990
- Future prospects for wood cellulose as reinforcement in organic polymer compositesPolymer Composites, 1989
- Influence of coupling agents and treatments on the mechanical properties of cellulose fiber–polystyrene compositesJournal of Applied Polymer Science, 1989
- The Efficiency of Cellulosic Fillers in Common Thermoplastics. Part 1. Filling without Processing Aids or Coupling AgentsInternational Journal of Polymeric Materials and Polymeric Biomaterials, 1984