A Single-Stage Soft-Switched Isolated Three-Phase DC–AC Converter With Three-Phase Unfolder
- 19 August 2019
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 35 (4) , 3601-3615
Abstract
This paper proposes a unidirectional, single-stage, three-phase, high-frequency-link (HFL) DC-AC converter. The converter uses three high frequency transformers (HFT) to provide galvanic isolation. In the primary, the converter has three half-bridge legs. In secondary three diode-bridge rectifiers are used. Each rectifier is followed by a half-bridge (unfolder) leg. The modulation strategy proposed in this paper ensures zero voltage switching (ZVS) of all six primary side switches over the entire line cycle without additional snubber circuit. The secondary half-bridge legs are switched at line frequency, incurring negligible switching loss. The proposed converter does not require any inter-stage bulky DC-link filter capacitor. Thus, the overall filtering requirement is reduced, and the converter reliability is improved. The high frequency galvanic isolation improves the converter power density. In the paper, the modulation strategy and converter operation are described in detail. The operation is validated in a 3.7 kW hardware prototype. Key experimental results are presented in the paper.Keywords
Funding Information
- Department of Science and Technology, Government of India
This publication has 29 references indexed in Scilit:
- A ZVS Pulsewidth Modulation Full-Bridge Converter With a Low-RMS-Current Resonant Auxiliary CircuitIEEE Transactions on Power Electronics, 2015
- Grid-Connected Photovoltaic Systems: An Overview of Recent Research and Emerging PV Converter TechnologyIEEE Industrial Electronics Magazine, 2015
- Hybrid Modulation Scheme for a High-Frequency AC-Link InverterIEEE Transactions on Power Electronics, 2015
- A Proportional ${\bm +}$ Multiresonant Controller for Three-Phase Four-Wire High-Frequency Link InverterIEEE Transactions on Power Electronics, 2009
- Analysis and design considerations of a load and line independent zero voltage switching full bridge DC/DC converter topologyIEEE Transactions on Power Electronics, 2002
- Zero-voltage and zero-current-switching full-bridge PWM converter using secondary active clampIEEE Transactions on Power Electronics, 1998
- Analysis and design for RCD clamped snubber used in output rectifier of phase-shift full-bridge ZVS convertersIEEE Transactions on Industrial Electronics, 1998
- High-frequency link DC/AC converter with suppressed voltage clamp circuits-naturally commutated phase angle control with self turn-off devicesIEEE Transactions on Industry Applications, 1996
- Pseudo-resonant full bridge DC/DC converterIEEE Transactions on Power Electronics, 1991
- A novel soft-switching full-bridge DC/DC converter: analysis, design considerations, and experimental results at 1.5 kW, 100 kHzIEEE Transactions on Power Electronics, 1991