Nitriding behaviour of Mg-Li alloy with surface mechanical nano-alloying pretreatment
Authors:
- 10 November 2020
- journal article
- research article
- Published by SAGE Publications in Surface Engineering
- Vol. 37 (9) , 1075-1083
Abstract
The thick titanium nitrides coating was fabricated on LZ91 alloy by surface mechanical nano-alloying (SMNAT) combined with gas nitriding. Experimental results showed that a nanostructured titanium coating with thickness of 50–80 μm was formed on surface of LZ91 alloy by SMNAT with pure titanium powders for 30 min. By adding of the aluminium powders into titanium powders during the SMNAT, a thicker Ti-Al composite coating with improved continuity and uniformity was obtained. After nitriding at 450°C, the whole Ti and Ti-Al coating were successfully nitrided. The surface layer of nitrided Ti coated sample is mainly composed of TiN, Ti2N, TiN0.3, TiN0.61 and Ti4N2.33 phases and the surface layer of nitrided Ti-Al coated sample is composed of Ti2N, TiN0.9, TiN0.3, Ti4N2.33, AlN, Ti3Al2N2 and AlTi2N phases. The hardness measurements demonstrated that the surface hardness of nitrided Ti coated and nitrided Ti-Al coated samples reached to 634 and 734 HV, respectively.Keywords
Funding Information
- Fundamental Research Funds for the Central Universities (JZ2018HGTB0265)
- National Natural Science Foundation of China (51701057)
- Natural Science Foundation of Anhui Province (1608085QE104)
- Anhui Wanan Co.Ltd (W2019JSKF0210)
- Industrial guiding fund of changfeng county and hefei university of technology (JZ2019QTXM0281)
This publication has 28 references indexed in Scilit:
- Low-temperature plasma nitriding of titanium layer on Ti/Al clad sheetMaterials & Design (1980-2015), 2013
- Anisotropic Diffusion Behavior of Al in Mg: Diffusion Couple Study Using Mg Single CrystalMetallurgical and Materials Transactions A, 2013
- Influence of Surface Mechanical Attrition Treatment Attrition Media on the Surface Contamination and Corrosion of MagnesiumCorrosion, 2012
- Effect of process parameters on the formation of Ti–Al coatings fabricated by mechanical millingJournal of Alloys and Compounds, 2009
- Coating a Cu plate with a Zr–Ti powder mixture using surface mechanical attrition treatmentSurface and Coatings Technology, 2009
- Coating metals by surface mechanical attrition treatmentJournal of Alloys and Compounds, 2007
- Fabrication of Ti–Al coatings by mechanical alloying methodSurface and Coatings Technology, 2006
- Nitriding Iron at Lower TemperaturesScience, 2003
- Protective coatings on magnesium and its alloys — a critical reviewJournal of Alloys and Compounds, 2002
- Internal Stress and Microstructure of Titanium Nitride CoatingsSurface Engineering, 1987