Abstract
Non-uniform heat flux in high-power electronic devices can induce local hotspots. To address hotspot thermal management, a hybrid microchannel heat sink featuring micro pin-fins with secondary channels (MPSCs) is proposed. Straight microchannels are used in the low-heat-flux region, while staggered pin-fins are arranged in the central hotspot region. Five models are considered: solid pin-fins without secondary channels (M1) and pin-fins with one-, three-, four-, and six-directional secondary channels (M2–M5). Over Re = 200–800, the thermal resistance of M3 is reduced by up to 43.3% compared with the SPMS, and the maximum PEC reaches 1.178. MPSC structures achieve better cooling at lower pumping power. At similar pumping power, the thermal resistance of M3 is 36.8% lower than the minimum value attainable by the SPMS. However, the marginal reduction in thermal resistance gradually weakens as the pumping power increases. The effects of hotspot heat flux and relative pin-fin height are investigated. MPSCs can withstand higher heat loads. Under a hotspot heat flux of 800 W/cm2, the maximum temperature of M3 remains below the safety threshold. Relative pin-fin height has a coupled effect on the thermal–hydraulic performance. At Re = 800, the PEC of M3 at RPH = 0.9 is about 2.8% higher than that at RPH = 1.0, and a PEC fitting equation is developed. The results show that the hybrid micro pin-fin heat sink with secondary channels disrupts the thermal boundary layer through internal flow diversion and local disturbance, thereby balancing hotspot suppression and pressure drop control. This design provides a reference for hotspot thermal management and thermal–hydraulic optimization of microchannel heat sinks.
Funding Information
  • Frontier Technologies R&D Program of Jiangsu Province (BF2024077)
  • Postgraduate Research & Practice Innovation Program of Jiangsu Province (KYCX25_2011)

This publication has 44 references indexed in Scilit: