Comparison of Toughening Effects of Various Additives on Phenolic Foam
Authors:
Open Access
- 19 January 2024
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 9 (4) , 4695-4704
Abstract
Phenolic foams (PFs) are considered excellent insulation materials owing to their flame retardancy and low thermal conductivity. However, their mechanical properties often lag behind those of other polymeric insulation materials. To fully exploit their properties and broaden end-use applications, the mechanical properties of PFs must be enhanced. In this study, various modifications were introduced into the PF matrix with the aim of enhancing its properties. The toughening effects of four additives: urea (U), nano clay (NC), sodium silicate (SS), and lignin (Li) were studied and compared. Changes that occurred in the density, cell morphology, thermal conductivity, compressive strength, and thermal stability after the addition of these fillers were analyzed. Both compressive strength and thermal stability increased with the inclusion of all additives, and the SS-toughened foam shows the biggest improvement. Li and NC addition resulted in a 34% improvement in compressive strength, while SS and U addition displayed increases of 52 and 11%, respectively. SS-toughened PF shows greater improvements in all of the important properties compared with those of the other toughened foams. Several PFs were prepared by changing the SS concentration to optimize the formulation, which yielded improvements in properties. The effects of SS concentration on density, thermal conductivity, and compressive strength were studied. The formulation with 0.37% sodium silicate concentration (PF-SS1) shows a 15% improvement in mechanical properties.Keywords
Funding Information
- Khansaheb Industries
This publication has 34 references indexed in Scilit:
- Pore structure of the phenolic porous material and its mechanical propertyJournal of Cellular Plastics, 2014
- Mechanical and Thermal Properties of Phenolic Foams Reinforced by Hollow Glass BeadsAdvanced Materials Research, 2014
- Effect of polyethylene glycol on the mechanical property, microstructure, thermal stability, and flame resistance of phenol–urea–formaldehyde foamsJournal of Materials Science, 2013
- Improvement in mechanical and thermal properties of phenolic foam reinforced with multiwalled carbon nanotubesJournal of Applied Polymer Science, 2013
- Preparation and characterization of foam ceramics from red mud and fly ash using sodium silicate as foaming agentCeramics International, 2013
- Formulation optimization of unreinforced and lignin nanoparticle-reinforced phenolic foams using an analysis of variance approachComposites Science and Technology, 2012
- Study on phenolic resin foam modified by montmorillonite and carbon fibersProcedia Engineering, 2012
- Preparation and Performance Research on Phenolic Insulation Foam Used Low-Temperature Foaming TechnologyAdvanced Materials Research, 2011
- Phenolic and Lignophenolic Closed Cells Foams: Thermal Conductivity and Other PropertiesPolymer-Plastics Technology and Engineering, 2003
- Low-cost and facile synthesis of mesocellular carbon foamsChemical Communications, 2002