Mapping Depletion of Lubricant Films on Antibiofouling Wrinkled Slippery Surfaces
- 31 August 2018
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 10 (39) , 33669-33677
Abstract
Slippery liquid infused porous surfaces (SLIPS) have recently gained a lot of attention because of their wide range of applications. We recently showed that SLIPS with most of their surface depleted of lubricant, as little lubricant as 0.02 ± 0.01 μL cm–1, were effective against marine biofouling. Characterization of the depletion and configuration of the immobilized liquid layer on SLIPS is crucial to optimizing their performance. Previous attempts at mapping lubricant thickness have been diffraction limited or indirectly measured thickness. Here, we use atomic force microscopy meniscus force measurements to directly map lubricant thickness with nanoscale resolution on wrinkled surfaces made from Teflon and poly(4-vinylpyridine) (P4VP). Using this method, we show that SLIPS are easily depleted and are effectively heterogeneous surfaces, where the majority of the surface is a thick lubricating layer stabilized by capillary forces and part nanothin layer stabilized long-range intermolecular forces. We found that the depleted silicone oil thickness on the tops of nonwettable (Teflon) wrinkles is approx. 5 nm, close to but greater than the minimum measurable thickness of approx. 3 nm. The silicone oil thickness on the tops of wettable (P4VP) wrinkles is approx. 15 nm. Surfaces in this state still show antibiofouling properties and thus show that a thick lubricating layer is not necessary for all favorable properties of SLIPS.Keywords
This publication has 39 references indexed in Scilit:
- Liquid-infused structured surfaces with exceptional anti-biofouling performanceProceedings of the National Academy of Sciences, 2012
- Bioinspired self-repairing slippery surfaces with pressure-stable omniphobicityNature, 2011
- Nanoscale condensation of water on self-assembled monolayersSoft Matter, 2011
- Controlled wrinkling as a novel method for the fabrication of patterned surfacesMicrochimica Acta, 2009
- Soft matter with hard skin: From skin wrinkles to templating and material characterizationSoft Matter, 2006
- Force measurements with the atomic force microscope: Technique, interpretation and applicationsSurface Science Reports, 2005
- Dewetting Patterns and Molecular Forces: A ReconciliationPhysical Review Letters, 2001
- Adhesion Forces between Surface-Modified AFM Tips and a Mica SurfaceLangmuir, 1996
- Molecular conformation and disjoining pressure of polymeric liquid filmsThe Journal of Chemical Physics, 1991
- Determination of lubricant film thickness on a particulate disk surface by atomic force microscopyIEEE Transactions on Magnetics, 1990