Effects of air-polishing powders on color stability of composite resins
Open Access
- 22 July 2011
- journal article
- Published by FapUNIFESP (SciELO) in Journal of Applied Oral Science
- Vol. 19 (5) , 505-510
Abstract
The purpose of this study was to investigate the effect of different air-polishing powders on the color stability of different types of composite resin restorative materials. Thirty cylindrical specimens (15×2 mm) were prepared for each of 7 composite resin restorative materials. All specimens were polished with a series of aluminum oxide polishing discs (Sof-Lex). The prepared specimens of each composite resin were randomly divided into 3 groups of 10 specimens each, for control (Group-C) and two air-powder applications (Group-CP: Cavitron Prophy-Jet; Group-PS: Sirona ProSmile prophylaxis powder). A standard air-polishing unit (ProSmile Handly) was used. All specimens were air-powdered for 10 s at 4-bar pressure. The distance of the spray nosel from the specimens was approximately 10 mm and angulation of the nosel was 90º. Specimens were stored in 100 mL of coffee (Nescafe Classic) for 24 h at 37ºC. Color measurement of all specimens was recorded before and after exposure to staining agent with a colorimeter (Minolta CR-300). Color differences (∆E*) between the 2 color measurements (baseline and after 24 h storage) were calculated. The data were analyzed with a 2-way ANOVA test, and mean values were compared by the Tukey HSD test (p≤0.05). According to the 2-way ANOVA results, composite resin restorative materials, air-polishing powders, and their interaction were statistically significant (p.05) and these groups demonstrated the highest ∆E* values. For Filtek Silorane and IntenS, the highest ∆E* values were observed in Group-PS. The lowest ∆E* values for all composite resin groups were observed in Group-C. When comparing the 7 composite resin restorative materials, Aelite Aesthetic Enemal demonstrated significantly less ∆E* values than the other composite resins tested. The highest ∆E* values were observed in Quixfil. Except for Quixfil, all control groups of composite resins that were polished Sof-Lex exhibited clinically acceptable ∆E values (<3.7). Air-polishing applications increased the color change for all composite resin restorative materials tested. Composite restorations may require re-polishing after air-polishing.Keywords
This publication has 25 references indexed in Scilit:
- Color Stability of Resin Composites after Immersion in Different DrinksDental Materials Journal, 2006
- The Effects of a Commercial Aluminum Airpolishing Powder on Dental Restorative MaterialsJournal of Prosthodontics, 2004
- The effect of surface finishing and storage solutions on the color stability of resin-based compositesThe Journal of the American Dental Association, 2004
- Effects of filler size, water, and alcohol on hardness and laboratory wear of dental compositesActa Odontologica Scandinavica, 2004
- Effect of surface finishing and storage media on bi-axial flexure strength and microhardness of resin-based composite.2003
- Effects of various finishing systems on the surface roughness and staining susceptibility of packable composite resinsDental Materials, 2003
- Surface finish of a new hybrid aesthetic restorative material.2002
- Properties of Packable Dental CompositesJournal of Esthetic and Restorative Dentistry, 2000
- The Surface Roughness of Restorative Materials and Dental Tissues After Polishing With Prophylaxis and Polishing PastesJournal of Periodontology, 1982
- Maintenance Phase of Periodontal TherapyJournal of Periodontology, 1981