Modeling of Size Effect on Tensile Flow Stress of Sheet Metal in Microforming
Author:
- 11 December 2008
- journal article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 131 (1) , 011002
Abstract
This investigation considers the size effect on the deformation behavior of simple tension in microforming and thus proposes a simple model of the tensile flow stress of sheet metal. Experimental results reveal that the measure of the flow stress can be represented as a hyperbolic function , which is a function of (sheet thickness/grain size). The predicted flow stress agrees very well with the published experiment. Notably, a specimen with smaller grains has lower normalized flow stress for a given . Since the material properties of the macroscale specimen do not pertain to the microscale, a critical condition that distinguishes the macroscale from the microscale in the tensile flow stress is subsequently proposed, based on the “affected zone” model, the pile-up theory of dislocations, and the Hall–Petch relation. The distribution of the predicted is similar to the experimental finding that the decreases as the grain size increases. However, the orientation-dependent factor is sensitive to . Hence, further study of the orientation-dependent factor is necessary to obtain a more accurate and, thus, to evaluate and understand better the tensile flow stress of sheet metal in microforming.
Keywords
This publication has 12 references indexed in Scilit:
- Size effects in thin sheet metal forming and its elastic–plastic constitutive modelMaterials & Design (1980-2015), 2007
- Modeling of the Size Effects on the Behavior of Metals in Microscale Deformation ProcessesJournal of Manufacturing Science and Engineering, 2006
- Microforming—from basic research to its realizationJournal of Materials Processing Technology, 2002
- MicroformingCIRP Annals, 2001
- Miniaturization in sheet metal workingJournal of Materials Processing Technology, 2000
- Estimation of compression flow stress from post-deformation hardness in Al-Mg alloysScripta Materialia, 1999
- Fundamentals on the Manufacturing of Sheet Metal MicropartsCIRP Annals, 1996
- Effect of specimen size on the flow stress of rod specimens of polycrystalline CuAl alloyScripta Metallurgica, 1979
- Effect of specimen thickness on mechanical properties of polycrystalline aggregates with various grain sizesActa Metallurgica, 1979
- The Deformation and Ageing of Mild Steel: III Discussion of ResultsProceedings of the Physical Society. Section B, 1951