σ-phase precipitation in 347HFG stainless steel
Authors:
- 1 July 2013
- journal article
- Published by SAGE Publications in Materials Science and Technology
- Vol. 29 (7) , 835-842
Abstract
The microstructural evolution of an 18Cr–12Ni stainless steel (347HFG), with a fine grain size (ASTM 7–10) has been investigated. In particular, σ-phase precipitation and growth have been evaluated. Results show that σ-phase is precipitated after as little as 1000 h aging at 750°C and M23C6 is present in all aged samples. The mean area fractions of σ-phase have been found to be 2·7 and 3·4 at 700 and 750°C respectively after 15 000 h aging. This is a higher area fraction of σ-phase than has been previously observed in standard 347H under these conditions. It is thought that the reduced grain size has provided an increase in nucleation sites and diffusion paths, therefore enhancing the precipitation of σ-phase. The results from this study are discussed with regards to the effect of precipitation on the service life of a 347HFG stainless steel tube operating in advanced supercritical boilers.Keywords
This publication has 10 references indexed in Scilit:
- Microstructural investigation of the oxide formed on TP 347H FG during long‐term steam oxidationMaterials and Corrosion, 2010
- Correlation between the degree of sensitization and stress corrosion cracking susceptibility of type 304H stainless steelCorrosion Science, 2009
- Failure investigation of secondary super-heater tubes in a power boilerEngineering Failure Analysis, 2009
- Long term creep properties and microstructure of SUPER304H, TP347HFG and HR3C for A-USC boilersEnergy Materials, 2007
- Comparative study on sigma phase precipitation of three types of stainless steels: Austenitic, superferritic and duplexMaterials Science and Technology, 2006
- Comparison between quantitative metallography and modeling of σ-phase particle growth in AISI 347 stainless steelMetallurgical and Materials Transactions A, 2005
- Microstructural evolution and change in hardness in type 304H stainless steel during long-term creepMaterials Science and Engineering: A, 2001
- Microstructural changes in austenitic stainless steels during long-term agingMaterials Science and Technology, 1986
- A method for quantitative analysis of delta-ferrite, sigma and M23C6 carbide phases in heat treated Type 316 stainless steel weldmentsJournal of Materials Science, 1982
- The influence of sigma phase on creep ductility in type 316 stainless steelScripta Metallurgica, 1979