CFD Based Erosion Modelling of Abrasive Waterjet Nozzle using Discrete Phase Method
Open Access
- 1 February 2016
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 114 (1) , 012016
Abstract
In Abrasive Waterjet (AWJ) machining, the nozzle is the most critical component that influences the performance, precision and economy. Exposure to a high speed jet and abrasives makes it susceptible to wear erosion which requires for frequent replacement. The present works attempts to simulate the erosion of the nozzle wall using computational fluid dynamics. The erosion rate of the nozzle was simulated under different operating conditions. The simulation was carried out in several steps which is flow modelling, particle tracking and erosion rate calculation. Discrete Phase Method (DPM) and K-ε turbulence model was used for the simulation. Result shows that different operating conditions affect the erosion rate as well as the flow interaction of water, air and abrasives. The simulation results correlates well with past work.Keywords
This publication has 16 references indexed in Scilit:
- The stability of 30-μm-diameter water jet for jet-guided laser machiningThe International Journal of Advanced Manufacturing Technology, 2014
- Modeling and numerical investigation of erosion rate for turbulent two-phase gas–solid flow in horizontal pipesPowder Technology, 2014
- Influence of waterjet peening and smoothing on the material surface and properties of stainless steel 304Surface and Coatings Technology, 2014
- Numerical prediction of the erosion due to particles in elbowsPowder Technology, 2014
- CFD based prediction of erosion rate in large scale wall-fired boilerApplied Thermal Engineering, 2012
- Modelling of pipe bend erosion by dilute particle suspensionsComputers & Chemical Engineering, 2012
- CFD Simulation of Flow in an Abrasive Water Suspension Jet: The Effect of Inlet Operating Pressure and Volume Fraction on Skin Friction and Exit Kinetic EnergyAdvances in Mechanical Engineering, 2012
- Computational fluid analysis of abrasive waterjet cutting headJournal of Mechanical Science and Technology, 2010
- The effects of system and geometric parameters on abrasive water jet nozzle wearInternational Journal of Machine Tools and Manufacture, 2002
- Monitoring the depth of abrasive waterjet penetrationInternational Journal of Machine Tools and Manufacture, 1992