Effective EMI Filter Design Method for Three-Phase Inverter Based Upon Software Noise Separation
Authors:
- 1 November 2010
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 25 (11) , 2797-2806
Abstract
This paper presents an electromagnetic interference (EMI) filter design method for a three-phase inverter applied to motor drives. The EMI filter design is based upon the results of software noise-separation method. Therefore, no hardware noise separator is required. Moreover, the presented EMI filter design approach provides systematic design procedure, and therefore, trial-and-error overhead is not required, and thereby, shortening the development time and saving the cost. The presented method determines common-mode choke and differential-mode choke based upon the required impedance to attenuate the noise. A three-phase inverter for inductor motor drives is used as the equipment under test (EUT), and the related conductive EMI filter is designed and verified. It will be shown that EMI filter designed by this systematic design method effectively attenuates the conductive EMI components to meet the requirement of EN 55011.Keywords
This publication has 23 references indexed in Scilit:
- Attenuation of Conducted EMI Emissions From an Inverter-Driven MotorIEEE Transactions on Power Electronics, 2008
- Common Mode EMI Noise Suppression for Bridgeless PFC ConvertersIEEE Transactions on Power Electronics, 2008
- Automatic EMI Measurement and Filter Design System for Telecom Power SuppliesIEEE Transactions on Instrumentation and Measurement, 2007
- Design Procedure of Common-mode Filter for Induction Motor Drive using Butterworth Function2007
- Software-based Separation of Conductive EMI Signals2006
- Novel three-phase CM/DM conducted emissions separator2005
- Differential mode EMC input filter design for three-phase AC-DC-AC sparse matrix PWM converters2004
- Conducted EMI characteristic and its implications to filter design in 3-phase diode front-end converters2004
- Measurement of conducted electromagnetic emissions in PWM motor drive systems without the need for an LISNIEEE Transactions on Electromagnetic Compatibility, 1999
- A procedure for designing EMI filters for AC line applicationsIEEE Transactions on Power Electronics, 1996