Stress relaxation cracking susceptibility evaluation in 347H stainless steel welds
Open Access
- 25 January 2024
- journal article
- research article
- Published by Springer Nature in Welding in the World
- Vol. 68 (3) , 657-667
Abstract
Stress relaxation cracking (SRC) has been reported as a dominant failure mechanism for 347H stainless steel welds at elevated service temperatures, occurring in either the heat-affected zone (HAZ) or fusion zone (FZ). In this study, SRC susceptibility of physically simulated HAZ and cross-welded E347-347H stainless steel welds was studied using a four-step accelerated SRC test with a thermomechanical physical simulator. The stress and temperature range studied represents weld-induced residual stress at 150–600 MPa and post-weld heat treatment temperatures between 800 and 1050 °C. For all temperature conditions, the cross-welded samples failed at a lower critical stress threshold than the simulated HAZ. A finite element model of a 50.8-mm-thick single-V groove weld was used to generate the residual stress maps induced by a 40-pass welding procedure, which in combination with the experimental threshold stress map predicted potential SRC failure locations. Postmortem microstructural evaluations were performed to identify contributing characteristics to SRC. It was found that HAZ samples exhibited a combination of creep void development, secondary cracks with intergranular fracture near grain boundary carbides, and eutectic phases. FZ samples showed brittle fracture with cracks propagating along straight, non-tortuous interdendritic grain boundaries.Keywords
Funding Information
- National Renewable Energy Lab
This publication has 17 references indexed in Scilit:
- A case study on failure of AISI 347H stabilized stainless steel pipe in a petrochemical plantCase Studies in Engineering Failure Analysis, 2017
- Concentrating Solar Power Gen3 Demonstration Roadmap2017
- Weldability and weld performance of candidate nickel based superalloys for advanced ultrasupercritical fossil power plants Part II: weldability and cross-weld creep performanceScience and Technology of Welding and Joining, 2016
- Stress-Relief Cracking in Simulated-Coarse-Grained Heat Affected Zone of a Creep-Resistant Steel2016
- Failure analysis on welded joints of 347H austenitic boiler tubesEngineering Failure Analysis, 2015
- Effect of aging at 700°C on precipitation and toughness of AISI 321 and AISI 347 austenitic stainless steel weldsNuclear Engineering and Design, 2005
- Laser surface-contouring and spline data-smoothing for residual stress measurementExperimental Mechanics, 2004
- Weld heat affected zone liquation cracking in type 347 stainless steelScience and Technology of Welding and Joining, 1997
- A new finite element model for welding heat sourcesMetallurgical Transactions B, 1984
- Metallurgical Factors Influencing Hot Ductility of Austenitic Steel Piping at Weld Heat-Affected Zone TemperaturesJournal of Engineering for Power, 1963