Steady-State Heat Flux Prediction to Slabs in a Walking Beam Furnace
- 2 January 2022
- journal article
- research article
- Published by Taylor & Francis in Heat Transfer Engineering
- Vol. 44 (1) , 39-56
Abstract
After casting steel slabs are reheated in a reheat furnace to temperatures in the range 1200-1250 °C in order to be suitable for rolling. The high energy requirements and the importance of reheating for quality control are the motivation behind numerically modelling the furnace. Computational fluid dynamics allows us to understand the fundamental physics with great detail. It is however unclear how assumptions of such models influence the results of the simulations. In this work a steady-state model was analyzed, and it was found that the chosen slab temperature profile can underestimate the average heat flux on the slab surface by 30%. A slab model was employed to simulate the transient slab temperatures which results in an underestimation of the average slab temperatures by about 500 °C for the case with reduced fluxes. The uniform slab temperature assumption also results in the overestimation of heat fluxes on its front and side face.Keywords
This publication has 22 references indexed in Scilit:
- Assessment of uniform temperature assumption in zoning on the numerical simulation of a walking beam reheating furnaceApplied Thermal Engineering, 2015
- Performance Evaluation of Two Heat Transfer Models of a Walking Beam Type Reheat FurnaceHeat Transfer Engineering, 2014
- Optimum residence time analysis for a walking beam type reheating furnaceInternational Journal of Heat and Mass Transfer, 2012
- Application of the Spectral Line-based Weighted-Sum-of-Gray-Gases model (SLWSGG) to the calculation of radiative heat transfer in steel reheating furnaces firing on low heating value gasesJournal of Physics: Conference Series, 2012
- Efficiency analysis of radiative slab heating in a walking-beam-type reheating furnaceEnergy, 2011
- A numerical analysis of slab heating characteristics in a walking beam type reheating furnaceInternational Journal of Heat and Mass Transfer, 2010
- A heat transfer model for the analysis of transient heating of the slab in a direct-fired walking beam type reheating furnaceInternational Journal of Heat and Mass Transfer, 2007
- The influence of the space between the billets on the productivity of a continuous walking-beam furnaceApplied Thermal Engineering, 2004
- Numerical Study of the Performance of a Regenerative FurnaceHeat Transfer Engineering, 2002
- Prediction of Transient Slab Temperature Distribution in the Re-heating Furnace of a Walking-beam Type for Rolling of Steel Slabs.ISIJ International, 2000