Comparative Effects of O2 Plasma and Thermal Annealing on the Physicochemical and Electrical Characteristics of iCVD pV3D3 Dielectric Films
Open Access
Abstract
Functional polymers are increasingly considered for semiconductor integration, but their properties may be altered by plasma and thermal processing. Here, 50 nm thick iCVD-grown pV3D3 dielectric films were subjected to O2 plasma treatment and thermal annealing at 250 and 300 °C, and the resulting physicochemical and electrical changes were comparatively investigated. O2 plasma treatment generated C–O and O–C=O surface bonding states and shifted the Si 2p spectrum toward higher binding energy, while the RMS roughness remained below 0.5 nm. In contrast, thermal annealing caused comparatively limited surface-chemical changes but substantially altered the electrical response. In particular, the 300 °C-annealed sample exhibited strongly suppressed capacitance and a pronounced deviation from the linear resistance–length relationship observed for the reference and lower-temperature conditions. These results indicate that plasma treatment predominantly modifies the near-surface chemistry of pV3D3, whereas elevated thermal processing can induce electrical changes that are not fully captured by surface-sensitive characterization. The combined analysis highlights the importance of thermal-budget control when integrating pV3D3 into semiconductor process flows.Keywords
Funding Information
- Seoul National University of Science and Technology
This publication has 22 references indexed in Scilit:
- Scalable Inter‐Dielectric Engineering via Vapor‐Phase Synthesis Process for Top‐Gate MoS 2 Thin‐Film TransistorSmall, 2025
- Study on Dry Etching of iCVD‐Grown pV3D3 Dielectric Polymer FilmSmall Methods, 2025
- Vapor-Phase Deposited Polymer Dielectric Layers for Organic Electronics: Design, Characteristics, and ApplicationsKorean Journal of Chemical Engineering, 2024
- Wafer Scale Insulation of High Aspect Ratio Through-Silicon Vias by iCVDACS Applied Materials & Interfaces, 2024
- Facilitating 3D Multichip Integration through Low-Temperature Polymer-to-Polymer BondingACS Applied Electronic Materials, 2024
- Designing Organic and Hybrid Surfaces and Devices with Initiated Chemical Vapor Deposition (iCVD)Advanced Materials, 2023
- Poly(V3D3), an iCVD polymer with promising dielectric properties for high voltage capacitorsSolid-State Electronics, 2021
- Plasma‐initiated chemical vapour deposition of organosiloxane thin films: From the growth mechanisms to ultrathin low‐k polymer insulating layersPlasma Processes and Polymers, 2020
- CVD Polymers for Devices and Device FabricationAdvanced Materials, 2016
- A Surface Tailoring Method of Ultrathin Polymer Gate Dielectrics for Organic Transistors: Improved Device Performance and the Thermal Stability ThereofAdvanced Functional Materials, 2015