Mass estimation of a quadcopter using IMU data
- 1 June 2017
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1260-1266
Abstract
In this paper, an approach to estimate the mass of a quadcopter using only inertial measurements and pilot commands is presented. For this purpose, a lateral dynamic model describing the relation between the roll rate and the lateral acceleration is formulated. Due to the quadcopter's inherent instability, a controller is used to stabilize the system and the data is collected in closed loop. Under the effect of feedback and disturbances, the inertial measurements used as input and output are correlated with the disturbances, which complicates the parameter estimation. The parameters of the model are estimated using several methods. The simulation and experimental results show that the instrumental-variable method has the best potential to estimate the mass of the quadcopter in this setup.Keywords
This publication has 11 references indexed in Scilit:
- A closed-loop instrumental variable approach to mass and center of mass estimation using IMU data2014
- Quadrotors and Accelerometers: State Estimation with an Improved Dynamic ModelIEEE Control Systems, 2014
- Introduction to feedback control of underactuated VTOLvehicles: A review of basic control design ideas and principlesIEEE Control Systems, 2013
- Vision-based autonomous mapping and exploration using a quadrotor MAV2012
- Multirotor Aerial Vehicles: Modeling, Estimation, and Control of QuadrotorIEEE Robotics & Automation Magazine, 2012
- Design, modeling, estimation and control for aerial grasping and manipulation2011
- Optimal instrumental variable method for closed-loop identificationIET Control Theory & Applications, 2011
- Autonomous MAV flight in indoor environments using single image perspective cues2011
- An overview on development of miniature unmanned rotorcraft systemsFrontiers of Electrical and Electronic Engineering in China, 2009
- Instrumental variable methods for closed-loop system identificationAutomatica, 2005