Du Ho
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Du Ho has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
Gustaf Hendeby
Division of Automatic Control, Department of Electrical Engineering, Linkoping University, SE-58183 Linkoping, Sweden
2 shared publications- Jonas Linder
ABB Corporate Research Västerås Sweden
2 shared publications Martin Enqvist
Division of Automatic Control, Department of Electrical Engineering, Linkoping University, SE-58183 Linkoping, Sweden
2 shared publications- Anh Tuan Phan
Université de Haute Alsace
1 shared publication - Gilles Hermann
Université de Haute Alsace
1 shared publication - Gustaf Hendeby
Linköping University
1 shared publication
Latest Publications
- Open Access
- 1 January 2020
- Published by Elsevier in IFAC-PapersOnLine
- Vol. 53 (2) , 712-717
A sensor-to-sensor model-based change detection approach for quadcopters
- 1 January 2020
- Published by Elsevier in IFAC-PapersOnLine
- Vol. 53 (2) , 712-717
Open AccessA sensor-to-sensor model-based change detection approach for quadcopters
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 192-197
Vertical modeling of a quadcopter for mass estimation and diagnosis purposes
In this work, we estimate a model of the vertical dynamics of a quadcopter and explain how this model can be used for mass estimation and diagnosis of system changes. First, a standard thrust model describing the relation between the calculated control signals of the rotors and the thrust that is commonly used in literature is estimated. The estimation results are compared to those using a refined thrust model and it turns out that the refined model gives a significant improvement. The combination of a nonlinear model and closed-loop data poses some challenges and it is shown that an instrumental variables approach can be used to obtain accurate estimates. Furthermore, we show that the refined model opens up for fault detection of the quadcopter. More specifically, this model can be used for mass estimation and also for diagnosis of other parameters that might vary between and during missions.
- 1 October 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 192-197
Vertical modeling of a quadcopter for mass estimation and diagnosis purposes
In this work, we estimate a model of the vertical dynamics of a quadcopter and explain how this model can be used for mass estimation and diagnosis of system changes. First, a standard thrust model describing the relation between the calculated control signals of the rotors and the thrust that is commonly used in literature is estimated. The estimation results are compared to those using a refined thrust model and it turns out that the refined model gives a significant improvement. The combination of a nonlinear model and closed-loop data poses some challenges and it is shown that an instrumental variables approach can be used to obtain accurate estimates. Furthermore, we show that the refined model opens up for fault detection of the quadcopter. More specifically, this model can be used for mass estimation and also for diagnosis of other parameters that might vary between and during missions.
- 1 June 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1260-1266
Mass estimation of a quadcopter using IMU data
In this paper, an approach to estimate the mass of a quadcopter using only inertial measurements and pilot commands is presented. For this purpose, a lateral dynamic model describing the relation between the roll rate and the lateral acceleration is formulated. Due to the quadcopter's inherent instability, a controller is used to stabilize the system and the data is collected in closed loop. Under the effect of feedback and disturbances, the inertial measurements used as input and output are correlated with the disturbances, which complicates the parameter estimation. The parameters of the model are estimated using several methods. The simulation and experimental results show that the instrumental-variable method has the best potential to estimate the mass of the quadcopter in this setup.
- 1 June 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1260-1266
Mass estimation of a quadcopter using IMU data
In this paper, an approach to estimate the mass of a quadcopter using only inertial measurements and pilot commands is presented. For this purpose, a lateral dynamic model describing the relation between the roll rate and the lateral acceleration is formulated. Due to the quadcopter's inherent instability, a controller is used to stabilize the system and the data is collected in closed loop. Under the effect of feedback and disturbances, the inertial measurements used as input and output are correlated with the disturbances, which complicates the parameter estimation. The parameters of the model are estimated using several methods. The simulation and experimental results show that the instrumental-variable method has the best potential to estimate the mass of the quadcopter in this setup.
- 1 January 2015
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1702 (1) , 150002
A new state-space model for three-phase systems for Kalman filtering with application to power quality estimation
For power quality issues like reducing harmonic pollution, reactive power and load unbalance, the estimation of the fundamental frequency of a power lines in a fast and precise way is essential. This paper introduces a new state-space model to be used with an extended Kalman filter (EKF) for estimating the frequency of distorted power system signals in real-time. The proposed model takes into account all the characteristics of a general three-phase power system and mainly the unbalance. Therefore, the symmetrical components of the power system, i.e., their amplitude and phase angle values, can also be deduced at each iteration from the proposed state-space model. The effectiveness of the method has been evaluated. Results and comparisons of online frequency estimation and symmetrical components identification show the efficiency of the proposed method for disturbed and time-varying signals.
- 1 January 2015
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1702 (1) , 150002
A new state-space model for three-phase systems for Kalman filtering with application to power quality estimation
For power quality issues like reducing harmonic pollution, reactive power and load unbalance, the estimation of the fundamental frequency of a power lines in a fast and precise way is essential. This paper introduces a new state-space model to be used with an extended Kalman filter (EKF) for estimating the frequency of distorted power system signals in real-time. The proposed model takes into account all the characteristics of a general three-phase power system and mainly the unbalance. Therefore, the symmetrical components of the power system, i.e., their amplitude and phase angle values, can also be deduced at each iteration from the proposed state-space model. The effectiveness of the method has been evaluated. Results and comparisons of online frequency estimation and symmetrical components identification show the efficiency of the proposed method for disturbed and time-varying signals.