Changes in Wood Plastic Composite Properties After Natural Weathering and Potential Microplastic Formation
Open Access
Abstract
Wood plastic composites (WPCs) have recently gained attention as alternatives to traditional wood materials for outdoor use, thanks to their enhanced moisture resistance and durability, which extends their service life. Discolouration as well as surface erosion has been observed during weathering for both WPCs with untreated and heat-treated wood. However, aspects such as changes in surface hydrophobicity, chemistry, and erosion in terms of microplastic formation have received less attention; this research aimed to evaluate these factors during natural weathering. Four types of WPC samples, consisting of 50% wood particles (untreated and heat-treated) and 50% polypropylene, were naturally weathered in Latvia for two years. The samples measured 240 mm × 240 mm × 5 mm. Results showed rapid colour changes, microcracks, and exposed wood particles, suggesting microplastic formation. ATR-FTIR analysis showed increased absorption at 1715 cm⁻¹ (carbonyl groups) and at 3410 cm−1 and 3460 cm−1, typical of wood, indicating chemical changes on the surface. These changes influenced surface hydrophobicity, roughness, and water penetration. In a relatively short exposure time, WPCs without proper additives undergo significant changes in their aesthetic and physical properties, leading to surface erosion and potential microplastic formation. This could challenge the perception of WPCs as environmentally friendly materials.Keywords
Funding Information
- Latvijas Zinātnes Padome (lzp-2022/1-0639, 10-24)
- Latvian State Institute of Wood Chemistry Bioeconomy Grant WoodREx project (lzp-2022/1-0639, 10-24)
This publication has 40 references indexed in Scilit:
- Weathering properties of wood-plastic composites based on heat-treated wood and polypropyleneComposites Part A: Applied Science and Manufacturing, 2020
- Influence of surface roughness on contact angle hysteresis and spreading workColloid and Polymer Science, 2020
- The environmental attributes of wood fiber composites with bio-based or petroleum-based plasticsThe International Journal of Life Cycle Assessment, 2020
- Accelerated weathering of fire-retarded wood–polypropylene compositesComposites Part A: Applied Science and Manufacturing, 2016
- Effects of UV weathering on surface properties of polypropylene composites reinforced with wood flour, lignin, and celluloseApplied Surface Science, 2014
- Water absorption of wood polypropylene composite sheet piles and its influence on mechanical propertiesConstruction and Building Materials, 2011
- Effects of wood species on durability and chemical changes of fungal decayed wood plastic compositesComposites Part A: Applied Science and Manufacturing, 2011
- Surface deterioration of wood-flour polypropylene composites by weathering trialsJournal of Wood Science, 2007
- Natural surface inactivation of Scots pine and Norway spruce evaluated by contact angle measurementsEuropean Journal of Wood and Wood Products, 1999
- The photodegradation of polypropylene. IV. UV stabilizer decompositionJournal of Applied Polymer Science, 1978