Study on mechanical properties of 2219 aluminum alloy bobbin tool friction stir welding
Authors:
Open Access
- 1 September 2023
- journal article
- research article
- Published by IOP Publishing in Materials Research Express
- Vol. 10 (9) , 096504
Abstract
The Bobbin tool friction stir welding (BT-FSW) process experiment was performed on 2219 aluminum alloy with different butt clearances and misalignments. The maximum allowable clearance and misalignment amount for BT-FSW were obtained, and the weld formation, mechanical properties and microstructure under different parameters were compared and analysed. The results show that the face and back sides of the weld joint surface are perfect and there are no defect inside with the butt clearance under 2 mm and the misalignment under 1.5 mm. During the increase of butt clearance and misalignment, the tensile strength of the weld will be decreased gradually. In comparison, the impact of misalignment on weld strength is lower than that of the butt clearance. The tensile strength from both of them will reach more than 60% of the base metal strength. The lowest hardness value occurs in the thermal-mechanical influence zone, which is 79.1HV, about 70% of the base metal hardness value. The microstructure characteristics are similar to those of conventional friction stir welding. The macroscopic morphology of the welded joint is typical ‘dumbbell type’, and there are many ‘dimples’ in the tensile fracture, which is a typical ductile fracture. A large number of dispersed phase particles (Al2Cu) were found in the dimples, which is the main reason for the decrease in mechanical strength and hardness compared with the substrate.Keywords
This publication has 40 references indexed in Scilit:
- Empirical modeling for the effects of welding factors on tensile properties of bobbin tool friction stir-welded 2219-T87 aluminum alloyThe International Journal of Advanced Manufacturing Technology, 2016
- Effect of tool rotational speed on the microstructure and mechanical properties of bobbin tool friction stir welding of Al–Li alloyMaterials & Design, 2015
- Friction Stir Welding of Discontinuously Reinforced Aluminum Matrix Composites: A ReviewActa Metallurgica Sinica (English Letters), 2014
- Effect of Segregation of Secondary Phase Particles and “S” Line on Tensile Fracture Behavior of Friction Stir-Welded 2024Al-T351 JointsMetallurgical and Materials Transactions A, 2013
- Effect of Friction Stir Welding Parameters on Thermal and Tensile Behavior of Aluminum Weldments Using Double Shoulder ToolsAdvanced Materials Research, 2012
- Friction stir welding characteristics of 2219-T6 aluminum alloy assisted by external non-rotational shoulderThe International Journal of Advanced Manufacturing Technology, 2012
- Effect of Alclad Layer on Material Flow and Defect Formation in Friction-Stir-Welded 2024 Aluminum AlloyMetallurgical and Materials Transactions A, 2010
- Effect of process parameters on friction stir welding of aluminum alloy 2219-T87The International Journal of Advanced Manufacturing Technology, 2010
- Microstructure and mechanical properties of friction stir welded joints in 2219-T6 aluminum alloyMaterials & Design (1980-2015), 2009
- Precipitate evolution in friction stir welding of 2219-T6 aluminum alloysMaterials Characterization, 2009