Optimization of Etching Time, Temperature of Metal Salts in Surface‐texturized Silicon Fabricated Through One‐Step Metal‐Assisted Chemical Etching
- 3 March 2025
- journal article
- Published by Wiley in Chemnanomat
- Vol. 11 (3)
Abstract
This study delves into the Metal‐Assisted Chemical Etching (MACE) of p‐type monocrystalline silicon wafers, with a focus on tailoring surface morphology for heightened performance as thermal absorbers. Employing diverse metal catalysts—specifically, nickel nitrate hexahydrate and silver nitrate salts—the investigation systematically explores the impact of catalyst type, etching time and temperature on nanostructure formation. One of the objectives was to maintain the etching temperature to be as low as possible through the application of the metal catalysts. Achieving >2 of thermal energy absorbance in the UV‐Vis‐NIR range required immersing samples in a nickel nitrate salt solution at room temperature for 60 minutes. Characterization through UV‐Vis‐NIR spectroscopy revealed reflectance and absorbance spectra, with silver nitrate salt‐etched samples demonstrating exceptional performance, achieving the lowest reflectance values within the critical wavelength range of 300–1800 nm. Notably, after 60 minutes of etching, silver nitrate salt‐etched samples produced reflectance values ranging from 0.19 % to 3.45 %. Optimized parameters for nickel nitrate salt‐etched samples were identified at 30 minutes of etching and 50 °C, showcasing an average reflectance of 1.54 %. The consideration of energy conservation was paramount, prompting the initial observation of each catalyst's performance during the etching process with no heating at room temperature. Subsequently, in the extended phase of the study, the etching temperature was gradually increased. Raising the etching temperature served as a method of varying the process parameter to observe its impact on the formation of surface nanostructures and absorbing performance. The study concludes with recommendations for future research, advocating for the exploration of additional metal catalysts and investigation of combined catalysts.Keywords
Funding Information
- Universiti Malaya (ST055-2022)
This publication has 41 references indexed in Scilit:
- Comparing metal assisted chemical etching of N and P-type silicon nanostructuresMicro and Nano Engineering, 2023
- Novel technique to study the wet chemical etching response of multi-crystalline silicon wafersMaterials Science and Engineering: B, 2023
- Silicon nanowires-based biosensors for the electrical detection of Escherichia coliBiosensors and Bioelectronics, 2022
- Progress on the intrinsic a-Si:H films for interface passivation of silicon heterojunction solar cells: A reviewJournal of Non-Crystalline Solids, 2021
- Optimization of etching time for broadband absorption enhancement in black silicon fabricated by one-step electroless silver-assisted wet chemical etchingOptik, 2019
- Enhanced etching rate of black silicon by Cu/Ni Co-assisted chemical etching processMaterials Science in Semiconductor Processing, 2018
- Effect of Silver-Assisted Chemical Vapor Etching on morphological properties and silicon solar cell performanceMaterials Science in Semiconductor Processing, 2017
- Effect of porous layer engineered with acid vapor etching on optical properties of solid silicon nanowire arraysMaterials & Design, 2016
- Nanomaterials and nanostructures for efficient light absorption and photovoltaicsNano Energy, 2012
- Optical properties of intrinsic silicon at 300 KProgress in Photovoltaics: Research and Applications, 1995