Abstract
The paper presents the results of an experimental study of the influence of the type of chip formation on the occurrence and development of regenerative self-oscillations during turning. The relationship between the nature of chip formation and the dynamic stability of the technological system in the cutting process is considered. Experimental studies were conducted when processing various structural materials that differ in the mechanism of plastic deformation and the nature of chip formation. It was established that when processing materials that form flowing chips, such as steel 45, copper M2, aluminum alloy D16 and lead C1, stable regenerative self-oscillations arise at certain ranges of cutting speeds. Their appearance is due to the relatively continuous nature of the plastic deformation of the material and the stable formation of the cut layer. Under these conditions, a positive feedback loop is formed between the change in the thickness of the cut layer and the oscillations of the elements of the technological system, which leads to the development of regenerative self-oscillations and a decrease in the stability of the cutting process. At the same time, during the processing of materials characterized by segmental chip formation, regenerative self-oscillations were not observed. The periodic formation of chip segments with a certain frequency and the adiabatic nature of the displacement of these segments can lead to the damping of regenerative self-oscillations. The results obtained show that the type of chip formation is one of the significant factors affecting the dynamic stability of the turning process. Confluent chip formation contributes to the emergence and development of regenerative self-oscillations, while segmental chip formation can completely suppress their development.

This publication has 20 references indexed in Scilit: