Kinetic Study of Lithium–Zinc Ferrite Synthesis under Electron Beam Heating Conditions
- 20 April 2022
- journal article
- research article
- Published by Pleiades Publishing Ltd in Inorganic Materials: Applied Research
- Vol. 13 (2) , 494-500
Abstract
In this paper, we consider the kinetic regularities of lithium–zinc ferrite synthesis under conditions of heating by a high-energy electron beam of mixtures of initial reagents Fe2O3–Li2CO3–ZnO of bulk density and pressed in a hydraulic press. Radiation-thermal synthesis of the samples was performed using an ILU-6 pulsed electron accelerator by heating them with a 2.4-MeV high-energy electron beam. The samples were heated to 600, 700, and 750°C and held at these temperatures for up to 120 min. For comparison with radiation-thermal synthesis, similar studies were carried out with traditional thermal annealing under the same conditions. An X-ray diffraction analysis of the synthesized samples was performed. The rate of ferrite formation was found to depend on both the heating method and the density of the mixture. Heating the mixture with an electron beam is shown to significantly accelerate the process of obtaining ferrite, which manifests itself in a decrease in the values of the kinetic parameters of the ferrite synthesis. An increase in the rate of ferrite formation under the effect of electrons is due to a significant decrease in the activation energy of the synthesis and a decrease in the pre-exponential factor in the temperature dependence.Keywords
This publication has 21 references indexed in Scilit:
- Influence of Radiation-Thermal Treatment on the Phase Composition and Structural Parameters of the SHS Product Based on W-Type HexaferriteRussian Physics Journal, 2013
- Effects of Annealing on Phase Evolution, Microstructure, and Magnetic Properties of Nanocrystalline Ball-Milled LiZnTi FerriteJournal of Electronic Materials, 2012
- Dielectric, morphological and structural properties of lithium ferrite powders prepared by solid state methodJournal of Non-Crystalline Solids, 2012
- Investigation of structural states and oxidation processes in Li0.5Fe2.5O4−δ using TG analysisJournal of Thermal Analysis and Calorimetry, 2011
- High permeability and low power loss of Ti and Zn substitution lithium ferrite in high frequency rangeJournal of Magnetism and Magnetic Materials, 2009
- Sintering characteristics of LiZn ferrites fabricated by a sol–gel processJournal of Magnetism and Magnetic Materials, 2009
- Development of magneto-dielectric materials based on Li-ferrite ceramicsJournal of Alloys and Compounds, 2008
- Electron beam induced diffusion controlled reaction in solidsSolid State Ionics, 1997
- Sintering under a high-power electron beamJournal of the Less Common Metals, 1986
- Fabrication and properties of microwave lithium ferritesIEEE Transactions on Magnetics, 1972