The effect of hybridization and stainless steel mesh on the post‐impact performance of needle punched banana/pineapple/unsaturated polyester composites
Authors:
- 22 August 2024
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 46 (1) , 127-140
Abstract
The main limitations of using natural fibers reinforced unsaturated polyester (UPE) composites is poor impact damage behaviors. This work focuses to improve impact damage resistance and residual strength of needle punched banana and pineapple fibers UPE composites by hybridization and incorporating stainless steel (SS) mesh. Different configurations such as banana/UPE (PB), pineapple/UPE (PP) and banana/pineapple/UPE (H) composites were fabricated. Later, SS mesh was incorporated in PB, PP and H composites which are denoted as BS, PS and HS respectively. All specimens were impacted with incident energy of 3.5 and 15 J using Fractovis instrumental low velocity impact tester at 2 and 4 m/s respectively. Subsequently, residual strength of impacted specimens was estimated using three point bending test. Results reveal that the HS composites have least residual dent of 0.89 and 3.9 mm and maximum contact force of 1507 and 1959 N were obtained under the impacted velocity of 2 and 4 m/s respectively, which indicated better damage resistance followed by PS, PP, BS, H and PB specimens. Similarly, the least absorbed energy of 1.9 and 12 J observed in HS composites showed better impact damage tolerance. Moreover, the damage degree and performance index were computed and validated with obtained results. The least reduction of residual strength of 1.2% and 3.2% in HS composites confirmed the better impact damage resistance as compared with all other configurations. Finally, microstructural analysis was performed to correlate the impact induced damage mechanisms. Highlights: HS composites exhibited the least residual dent of 0.89 mm Impact load bearing capacity of HS composites was drastically improved by 280% Strong interfacial adhesion between the banana fiber and SS mesh was observed HS composites showed greater impact resistance under both velocities There is no significant reduction of residual strength in HS compositesKeywords
This publication has 32 references indexed in Scilit:
- Exploration of novel fiber‐metal laminates sandwich structures with cellulosic ramie woven corePolymer Composites, 2022
- A current advancement on the role of lignin as sustainable reinforcement material in biopolymeric blendsJournal of Materials Research and Technology, 2021
- A comprehensive review on light weight kenaf fiber for automobilesInternational Journal of Lightweight Materials and Manufacture, 2020
- Thermo-mechanical and morphological characterization of needle punched non-woven banana fiber reinforced polymer compositesComposites Science and Technology, 2020
- Acoustic emission based investigation on the effect of temperature and hybridization on drop weight impact and post-impact residual strength of hemp and basalt fibres reinforced polymer composite laminatesComposites Part B: Engineering, 2019
- Exploration of energy absorption and viscoelastic behavior of CFRPs subjected to low velocity impactComposites Part B: Engineering, 2019
- Effect of hybridization on the mode II fracture toughness properties of flax/vinyl ester compositesPolymer Composites, 2015
- Effect of temperature and hybridisation on the low velocity impact behavior of hemp-basalt/epoxy compositesComposite Structures, 2015
- Effect of water absorption on the mechanical properties of hemp fibre reinforced unsaturated polyester compositesComposites Science and Technology, 2007
- Atomic force microscopy characterization of the surface wettability of natural fibresApplied Surface Science, 2007