SAW tags for the 6-GHz range
- 2 December 2014
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
- Vol. 61 (12) , 2149-2152
Abstract
The possibility of using 6-GHz frequencies for passive SAW tags is discussed. An example of an inline 6-GHz SAW tag design is presented. Supposing that an ultrawide frequency bandwidth B = 775 MHz can be used, the tag dimensions can be significantly reduced and the loss of reflected response remains at an acceptable level of around 50 dB. The devices were manufactured using E-beam lithography and, probed on wafer, show performance close to predicted, including the loss level of approximately 55 dB. The possibility of high-throughput manufacturing by combining nano-imprint and e-beam lithography is discussed.Keywords
This publication has 6 references indexed in Scilit:
- Fabrication of SAW resonators on Quartz and Langasite using Nano-Imprint Lithography2010
- Review on SAW RFID tagsIEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2010
- Anti-collision methods for global SAW RFID tag systems2005
- Minimum-loss short reflectors on 128/spl deg/ LiNbO/sub 3/IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control, 2004
- 10 GHz range extremely low-loss ladder type surface acoustic wave filter2002
- Rigorous analysis of finite SAW devices with arbitrary electrode geometries2002