Fractional Separation of Hemicelluloses and Lignin in High Yield and Purity from Mild Ball-Milled Periploca sepium
Authors:
- 8 August 2008
- journal article
- research article
- Published by Taylor & Francis in Separation Science and Technology
- Vol. 43 (11-12) , 3351-3375
Abstract
A novel three-step procedure for separation of hemicelluloses and lignin with high yield and purity was proposed in this study, where wood is mildly milled and successively extracted to produce three hemicellulosic and lignin fractions representing the total hemicelluloses and lignin in wood. The sequential treatments of the mild ball-milled Periploca sepium with 80% aqueous dioxane containing 0.05 M HCl at 85°C for 4 h, DMSO at 85°C for 4 h, and 8% NaOH at 50°C for 3 h resulted in a total release of over 85% of the original hemicelluloses and 86% of the original lignin. In particular, approximately 36% of the original hemicelluloses and 50% of the original lignin were separated during the first mild acidolytic hydrolysis process after low intensity milling. The structure of the acidic dioxane-, DMSO-, and alkali-soluble hemicellulosic and lignin fractions were elucidated using wet chemical analysis, FT-IR, and solution-state 1H, 13C, and 31P NMR techniques. Results showed that both the mild ball milling and the mild acidolysis under the conditions given did not affect the separated lignin macromolecular structure. On the other hand, the mild acidolytic hydrolysis condition did cause substantial hemicellulosic depolymerization exception for a significant cleavage the ether linkages between lignin and hemicelluloses. The acidic dioxane-soluble lignin fraction was structurally different from the DMSO- and alkali-soluble lignin preparations and may originate mainly from the primary wall, while the alkali-soluble lignin preparation was mainly released from the secondary wall of Periploca sepium. Furthermore, it was found that the acidic dioxane-soluble hemicelluloses mainly contained more branched and less acidic arabinoxylans, and the 8% NaOH-soluble hemicellulosic fraction H3 was both less branched and less acidic in structure, whereas the DMSO-soluble hemicelluloses were more acidic but less branched and consisted mainly of 4-O-methylglucuronoarabinoxylan.Keywords
This publication has 33 references indexed in Scilit:
- Cell wall polysaccharides in differentiating anthers and pistils of Lolium perenneProtoplasma, 2006
- Elucidation of the structure of cellulolytic enzyme ligninHolzforschung, 2006
- Quantitative evaluation of milling effects on lignin structure during the isolation process of milled wood ligninJournal of Wood Science, 2005
- Sustainable Bio-Composites from Renewable Resources: Opportunities and Challenges in the Green Materials WorldJournal of Polymers and the Environment, 2002
- Studies on the Effect of Ball Milling on Lignin Structure Using a Modified DFRC MethodJournal of Agricultural and Food Chemistry, 2001
- Molecular biology of the plant cell wall: searching for the genes that define structure, architecture and dynamicsPlant Molecular Biology, 2001
- The growth of man-made forests of Haloxylon ammodendron and their soil water contents in the Minqin desert region, Gansu Province, ChinaJournal of Arid Environments, 1989
- Afforestation for sand fixation in ChinaJournal of Arid Environments, 1989
- Comparative Studies on Cellulolytic Enzyme Lignin and Milled Wood Lignin of Sweetgum and SpruceHolzforschung, 1975
- Isolation of Lignin from Finely Divided Wood with Neutral SolventsNature, 1954