Stability of GFRP composites with varied fractions of reinforcement exposed to ageing processes outdoors
Authors:
- 19 November 2020
- journal article
- research article
- Published by SAGE Publications in Polymers and Polymer Composites
- Vol. 29 (9) , 1485-1494
Abstract
The effects of outdoor ageing on various compositions of glass fibre reinforced plastic (GFRP) composites were studied. Changes in the interlaminar shear strength (ILSS) of hand-laid samples with 50–60 wt.% of fibre were determined by three-point bending and glass transition temperature (Tg) measurements. SEM analysis was carried out for exploring the mode of failure. The moisture ingress rate and extent were concentration-dependent at first, but became increasingly dependent on the fibre-matrix interfacial area. The ILSS initially fluctuated and then showed a decreasing trend with time, especially for the higher fibre concentrations. ILSS variations were zigzag initially and showed a lowering trend after the initial periods. Rate of lowering of ILSS was the highest for samples with the highest fraction reinforcement. Weight fraction reinforcement didn’t have any significant effect on the Tg variations. SEM fractograph revealed excessive fracture and fragmentation for the composite samples with the highest weight percentage reinforcement.Keywords
This publication has 20 references indexed in Scilit:
- Influences of weave parameters on the mechanical behavior and fracture mechanisms of multidirectional angle-interlock 3D woven compositesMaterials Today Communications, 2020
- The influence of fiber volume fraction and fiber length on the evolution of pore content and the paintability of sheet molding compoundsComposites Part B: Engineering, 2020
- A novel investigation on durability of GRE composite pipe for prolonged sea water transportationComposites Communications, 2020
- Probabilistic fatigue life modelling of FRP composites for constructionConstruction and Building Materials, 2019
- Three-dimensional microscopic assessment of randomly distributed representative volume elements for high fiber volume fraction unidirectional compositesComposite Structures, 2018
- Environmental damage and degradation of FRP composites: A review reportPolymer Composites, 2014
- Environmental stability of GFRP laminated composites: an emphasis on mechanical behaviourAircraft Engineering and Aerospace Technology, 2010
- Influence of oxidative environments on damage in c/epoxy laminates subjected to thermal cyclingComposites Science and Technology, 2004
- Thermo-Oxidative Stability of High Performance Composites under Thermal Cycling ConditionsJournal of Composite Materials, 2001
- Effects of Fiber Volume Fraction on Mechanical Properties of SiC‐Fiber/Si 3 N 4 ‐Matrix CompositesJournal of the American Ceramic Society, 1994