State-dependent dilatancy of sand based on hollow cylinder laboratory tests under shear strain cycles
Authors:
Open Access
- 2 July 2024
- conference paper
- Published by EDP Sciences in E3S Web of Conferences
- Vol. 544, 06002
Abstract
The present study is devoted to the investigation of the dilatancy behaviour of a fine sand based on hollow cylinder tests. Medium and dense samples were tested at a constant average γ = 1, 2, 3 and 4%. Dilatancy curves along with shear wave velocity measurements to investigate the influence of the shear strain amplitude γampl in the shear modulus degradation curve are presented and discussed. The measured stress and strain paths were used to compare the performance of four advanced constitutive models especially in describing the dilatancy behaviour of sand. From the perspective of their constitutive equations, the differences between the simulations with various material models are examined. It may be concluded that all four models allow a proper prediction of torsional shear tests as long as a proper calibration of the material parameters is secured.Keywords
This publication has 43 references indexed in Scilit:
- Comparison of two small-strain concepts: ISA and intergranular strain applied to barodesyActa Geotechnica, 2022
- Inspection of four advanced constitutive models for fine-grained soils under monotonic and cyclic loadingActa Geotechnica, 2022
- AVISA: anisotropic visco-ISA model and its performance at cyclic loadingActa Geotechnica, 2020
- Inspection of three sophisticated constitutive models based on monotonic and cyclic tests on fine sand: Hypoplasticity vs. Sanisand vs. ISASoil Dynamics and Earthquake Engineering, 2019
- A Constitutive Model with a Historiotropic Yield Surface for Sands2019
- ISA model: A constitutive model for soils with yield surface in the intergranular strain spaceInternational Journal for Numerical and Analytical Methods in Geomechanics, 2015
- Stress–dilatancy relationships of sand in the simulation of volumetric behavior during cyclic torsional shear loadingsSoils and Foundations, 2014
- Assessment of silty sand liquefaction potential using hollow torsional tests—An energy approachSoil Dynamics and Earthquake Engineering, 2011
- SANISAND: Simple anisotropic sand plasticity modelInternational Journal for Numerical and Analytical Methods in Geomechanics, 2007
- A hypoplastic relation for granular materials with a predefined limit state surfaceMechanics of Cohesive-frictional Materials, 1996