LKLukas Knittel

Lukas Knittel

*This is an algorithmically generated author record based on publicly available information.

Lukas Knittel has a total of 20 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • On liquefaction behaviour of partially saturated sand

    by Lukas Knittel, Wolfgang Lieske

    Soil liquefaction caused by earthquakes is a devastating occurrence that can compromise the foundations of buildings and other structures, leading to considerable economic losses. Among the new remedies against liquefaction, Induced Partial Saturation (IPS) is regarded as one of the most promising technologies. In order to improve liquefaction resistance and the fluid phase‘s compressibility, gas or air bubbles are introduced into the pore water of sandy soils. This article deals with the general laboratory evaluation of a sand under partially saturated conditions and under cyclic loading to assess if this technology is applicable for a ground improvement of the examined soil. The use of the Axis Translation Technique for sample desaturation and diffusion‐stable butyl membranes significantly influences the laboratory results. Additionally, it is found that the trapped air bubbles of the partially saturated samples act like a damping mechanism, which are reflected in the stress paths of the deviator stress q over the mean pressure p with an inclination of 1 : 3.

  • Open Access

    Complex High‐Cyclic Loading in an Accumulation Model for Sand

    by Patrick Staubach, Lukas Knittel, Torsten Wichtmann

    Experimental evidence indicates that multidimensional cyclic loading of soils causes larger accumulation of deformations than equivalent one‐dimensional loading. The response of sand to high‐cyclic loading with 10,000 cycles and up to four‐dimensional stress paths (i.e., four independent oscillating components) is examined in 120 triaxial and hollow cylinder tests in this work to extend these findings. With increasing number of oscillating stress components, the accumulation of permanent strains tends to increase. It is demonstrated that the definition of the multidimensional strain amplitude incorporated in the high‐cycle accumulation (HCA) model can account for this. The validation of the HCA model for complex cyclic loading is complemented by the simulation of model tests on monopile foundations of offshore wind turbines subjected to multidirectional cyclic loading, for which the consideration of spatially variable cyclic loading with nonconstant load amplitudes in the HCA model is discussed. For this purpose, an extension of the HCA model considering multiple strain amplitudes is presented.


  • Untersuchungen zum Verflüssigungswiderstand eines Tagebau‐Kippenbodens bei Anregung durch erdbebentypische Signale

    by Lukas Knittel, Jan Machaček, Sabine Gehring, Paul Raabe, Dieter Dahmen, Torsten Wichtmann, Hans Henning Stutz

    Für die Böschungen der geplanten Tagebauseen im Rheinischen Revier muss der Nachweis der Standsicherheit unter Erdbebeneinwirkung erbracht werden. Hierfür sind laut der Richtlinie für die Untersuchung der Standsicherheit von Böschungen der im Tagebau betriebenen Braunkohlenbergwerke (RfS – Richtline für Standsicherheitsuntersuchungen [1]) die bleibenden Böschungen so zu gestalten und aufzubauen, dass eine Bodenverflüssigung „nicht zu besorgen“ ist. Für den Nachweis gegen Bodenverflüssigung, bei dem Einwirkungen und Bodenwiderstände lokal miteinander verglichen werden, wird das irreguläre Erdbebensignal in ein reguläres Signal mit einer äquivalenten Anzahl an Zyklen und konstanter Amplitude überführt. Im Rahmen dieses Beitrags wird diese Konvertierung für ein typisches Erdbebensignal des Rheinischen Reviers untersucht, welches aus einer dynamischen Finite‐Elemente‐Berechnung erhalten wurde. Zur Untersuchung des Verflüssigungsverhaltens eines Tagebau‐Kippenbodens bei Einwirkung dieses Erdbebensignals werden Triaxialversuche mit vertikaler zyklischer Belastung und Hohlzylindertriaxialversuche mit zyklischer Torsionsbeanspruchung durchgeführt. Die Ergebnisse dieser Versuche werden mit den Daten aus weiteren Versuchen mit konstanter Amplitude verglichen. Es kann gezeigt werden, dass der Faktor β zur Konvertierung von irregulären in reguläre Signale von der Art der Beanspruchung und der Größe der statischen Schub‐ bzw. Deviatorspannung abhängt. Auf Basis der Versuche werden Empfehlungen für den Ansatz von β für das Rheinische Revier gegeben.


  • Open Access

    State-dependent dilatancy of sand based on hollow cylinder laboratory tests under shear strain cycles

    by Lukas Knittel, Merita Tafili

    The present study is devoted to the investigation of the dilatancy behaviour of a fine sand based on hollow cylinder tests. Medium and dense samples were tested at a constant average γ = 1, 2, 3 and 4%. Dilatancy curves along with shear wave velocity measurements to investigate the influence of the shear strain amplitude γampl in the shear modulus degradation curve are presented and discussed. The measured stress and strain paths were used to compare the performance of four advanced constitutive models especially in describing the dilatancy behaviour of sand. From the perspective of their constitutive equations, the differences between the simulations with various material models are examined. It may be concluded that all four models allow a proper prediction of torsional shear tests as long as a proper calibration of the material parameters is secured.


  • Feldversuch zum Rüttelstopfsäuleneinbau und Betrachtungen zur Hohlraumaufweitung

    by Luis Mugele, Lukas Knittel, Vladimir Osinov, Paul Pandrea, Hans Henning Stutz

    Die Rüttelstopfverdichtung kommt als Baugrundverbesserung weltweit in fein‐ und grobkörnigen Böden zum Einsatz. Jedoch sind die Zustandsänderungen des anstehenden Bodens infolge des vollverdrängenden Säuleneinbaus und der induzierten Vibration noch nicht ausreichend untersucht. Im ersten Teil dieses Beitrags werden daher in einem Feldversuch die Auswirkungen der Rüttelstopfsäulenherstellung auf den Zustand des anstehenden Bodens untersucht. Dabei zeigt sich, dass der Rüttelstopfsäuleneinbau in grobkörnigen Böden zu einer Verbesserung der bautechnischen Eigenschaften des anstehenden Bodens führen kann. Motiviert durch den Feldversuch betrachtet der zweite Teil der Arbeit anhand von simplifizierten Beispielen einen grundsätzlichen Vergleich verschiedener Hohlraumaufweitungsprozesse. Mithilfe eines hypoplastischen Stoffmodells wird dabei die Aufweitung eines Hohlraums infolge (1) einer monotonen und infolge (2) einer zyklischen Belastung betrachtet. Beide Fälle werden im Hinblick auf eine qualitative Übertragbarkeit auf die Modellierung der Säuleninstallation verglichen. Es zeigt sich ein qualitativ unterschiedliches Bodenverhalten: Eine monotone Aufweitung führt zum kritischen Zustand im Boden, während eine zyklische Aufweitung in Abhängigkeit von der Durchlässigkeit zu einer Verdichtung und/oder einer Spannungsrelaxation führt. Eine vollständige Vernachlässigung der Rüttlervibration in entsprechenden numerischen Modellen erscheint daher nicht zutreffend.


  • Open Access

    Experimental determination of hypoplastic parameters and cyclic numerical analysis for railway bridge backfills

    by A. Stastny, L. Knittel, T. Meier, F. Tschuchnigg

    Long integral bridges experience an enhanced cyclic soil structure interaction with their granular backfills, especially due to seasonal thermal loading. For numerical modelling of this interaction behaviour under cyclic loading, it is important to employ a suitable constitutive model and calibrate it thoroughly. However, up to the present, experimental data and calibrated soil models for this purpose with focus on typical well-graded coarse-grained bridge backfill materials are rarely available in the literature. Therefore, one aim of this paper is to present results of a comprehensive cyclic laboratory testing programme on highly compacted gravel backfill material. Based on this, a hypoplastic constitutive model with intergranular strain extension for small strain and cyclic behaviour is calibrated and evaluated against the experimental test data. The soil model’s abilities and limitations are discussed at element test level. In addition, cyclic FE analyses of an integral bridge are conducted with several hypoplastic parameter sets from the literature and compared to the calibrated gravel backfill material. The investigation highlights that poorly-graded sands show significantly smaller cyclic earth pressures compared to well-graded gravels intended for the backfilling of a bridge. The soil structure interaction behaviour is clearly governed by the general soil model stiffness, including the small strain stiffness.


  • Open Access

    The high-cyclic model for sand tested beyond the usual ranges of application

    by L. Knittel, A. Lamparter, A. Niemunis, H. H. Stutz

    The high-cycle accumulation (HCA) model proposed by Niemunis et al. (Comput Geotech 32(4):245–263, 2005) predicts permanent deformations due cyclic loading with many small cycles (i.e. $$N \ge 10^4$$ N ≥ 10 4 cycles of strain amplitudes $${\varepsilon }^{{\rm ampl}}\le 10^{-3}$$ ε ampl ≤ 10 - 3 ). In the presented tests, the pressure range $$p^{{\rm av}}$$ p av is extended from 3 to 9 bar; the influence of the void ratio $$e \in (0.72, 0.95)$$ e ∈ ( 0.72 , 0.95 ) and amplitudes of strains $$\varepsilon ^{{\rm ampl}} \in (0.1{\%}, 1{\%})$$ ε ampl ∈ ( 0.1 % , 1 % ) is tested in the extended range. Some empirical HCA functions could be confirmed and some require modifications. An interesting qualitative controversy pertains to the direction of circulation in the P–Q-plane for a validation of the polarization function $$f_\pi $$ f π , which does influence the rate of accumulation contrarily to the HCA assumption. The previous assumption that $$\dot{\varepsilon }^{{{\rm acc}}}$$ ε ˙ acc remains constant above a certain pressure level, i.e. is independent of $$p^{{{\rm av}}}$$ p av , was experimentally refuted. Investigations on the cyclic preloading ( $$\dot{f}_N$$ f ˙ N ) using 21 cyclic triaxial tests with varried monotonic strain paths between the cycle packages found a relationship of the direction of the monotonic strain path and the capacity to reduce cyclic preloading. This study’s findings deepen the understanding of how cyclic preloading is reduced, but the tests also highlight the need for future research in the area.