Stability, Control, and Constraint Enforcement of Piston Motion in a Hydraulic Free-Piston Engine
Authors:
- 10 October 2016
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Control Systems Technology
- Vol. 25 (4) , 1284-1296
Abstract
A free-piston engine (FPE) requires stabilizing feedback control to manage piston motion and ensure safe operation. A high-fidelity model, which simulates the FPE behavior by combining dynamic, thermodynamic, and hydraulic submodels, is exploited as an engine surrogate for control development. A control-oriented model implicitly describes the FPE piston turnaround position using energy balance principles for an idealized Otto cycle. Local eigenvalues of the control-oriented model suggest that the FPE system is open-loop unstable. The control system relies on dynamic inversion and state feedback to stabilize the plant and track a target piston turnaround position. A robust reference governor is introduced to manage load changes, such that the piston position does not violate constraints, even in the presence of parameter uncertainty. In high-fidelity simulations, the reference governor constrains piston turnaround position to ±0.5 mm of the target during a load change.Keywords
Funding Information
- United States Environmental Protection Agency
This publication has 20 references indexed in Scilit:
- The control of a free-piston engine generator. Part 2: Engine dynamics and piston motion controlApplied Energy, 2010
- Control of dual hydraulic free piston engineInternational Journal of Vehicle Autonomous Systems, 2006
- Load governor for fuel cell oxygen starvation protection: a robust nonlinear reference governor approachIEEE Transactions on Control Systems Technology, 2005
- Validation and sensitivity analysis of a two zone Diesel engine model for combustion and emissions predictionEnergy Conversion and Management, 2004
- Instantaneous friction components model for transient engine operationProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 2000
- A stochastic-experimental investigation of the cyclic pressure variation in a di single-cylinder diesel engineInternational Journal of Energy Research, 1992
- Development and Use of a Computer Simulation of the Turbocompounded Diesel System for Engine Performance and Component Heat Transfer StudiesSAE International Journal of Advances and Current Practices in Mobility, 1986
- A New Approach to Evaluate Instantaneous Friction and Its Components in Internal Combustion EnginesSAE International Journal of Advances and Current Practices in Mobility, 1984
- A Combustion Correlation for Diesel Engine SimulationSAE International Journal of Advances and Current Practices in Mobility, 1980
- Advanced Approaches for Heat Transfer CalculationsSAE International Journal of Advances and Current Practices in Mobility, 1979