Study of Al/St laminated sheet and constituent layers in radial pressure-assisted hydrodynamic deep drawing
- 27 September 2016
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 32 (1) , 54-61
Abstract
In this research, radial pressure-assisted hydrodynamic deep drawing of single- and bilayer cups is studied using finite-element and experimental methods. The reason for using laminated composites is to take the combinatorial benefits of single materials, such as higher strength-to-weight ratio, improved corrosion and abrasion resistance, more favorable thermal and electrical characteristics, and even lower commercial price. Safe forming area and probability of failure occurrence are predicted for both single- and bilayer sheets using 3D process window diagram (PWD) as a practical tool based on the effective geometrical parameters on the pressure-drawing ratio. The effects of layers arrangement on the forming behavior of laminated sheets were also analyzed in different pressure loading paths. The results show that the aluminum/steel composite has a wider forming pressure range, higher drawing ratio and lower geometrical limitations compared with the single-layer aluminum in identical conditions. It is found that a thin layer of steel as the outer layer improves the formability of aluminum.Keywords
This publication has 13 references indexed in Scilit:
- Research on Process Window Diagrams of Tube-Compression by Viscous Pressure FormingJournal of Materials Engineering and Performance, 2014
- Deep drawing process of steel/brass laminated sheetsComposites Part B: Engineering, 2013
- Study of the Effect of Material Properties and Sheet Thickness on Formability of Conical Parts in Hydro-Mechanical Deep Drawing Assisted by Radial PressureAdvanced Materials Research, 2012
- Deep Drawing of Aluminum Alloys Using a Novel Hydroforming ToolingMaterials and Manufacturing Processes, 2011
- Investigation of hydrodynamic deep drawing for conical–cylindrical cupsThe International Journal of Advanced Manufacturing Technology, 2011
- Analysis of punch velocity dependent process window in micro deep drawingProduction Engineering, 2010
- Hydromechanical deep drawing of cups with stepped geometriesJournal of Materials Processing Technology, 2008
- Numerical and experimental confirmation of the calibration stage's effect in multi-operation sheet hydroforming using poor-formability materialsJournal of Materials Processing Technology, 2008
- Prediction of forming limit in hydro-mechanical deep drawing of steel sheets using ductile fracture criterionMetals and Materials International, 2006
- Investigation into hydrodynamic deep drawing assisted by radial pressureJournal of Materials Processing Technology, 2005