Investigation of the Reaction Kinetics of a Sinter-Reduction Process in the Thermal Reserve Zone of a Blast Furnace Using a Modified Sectioning Method
Open Access
Abstract
With the development of large-scale and high-performing blast furnaces, it is necessary to extensively study the reaction characteristics and related kinetic parameters of sinters in their heat reserve area. Under reducing atmosphere conditions, the reduction of iron oxide in sinter is closely related to the gasification reaction of coke. Based on a simulation experiment, the transition point from chemical reactions to diffusion and the related kinetic parameters were determined through a sectioning method. The results showed that increasing the proportion of low-grade coke increased the chemical-reaction rate, but it slightly decreased the mass-transfer and diffusion rates. An increase in the coke particle size increased the chemical-reaction, mass-transfer, and diffusion rates. However, an increase in the CO2 volume fraction in gas reduced the chemical-reaction, diffusion, and mass-transfer rates. The mixing ratio of coke and sinters increased the chemical-reaction rate, but it decreased the mass-transfer and diffusion rates. The rate constant of the chemical reactions in the early stage was three orders of magnitude higher than that of the diffusion and mass-transfer coefficients, and the fitting degree was obviously better than that of the molecular diffusion in the later stage. Based on the thermodynamics of irreversible processes, the interference of the chemical reactions with the diffusion and mass transfer in the near-equilibrium region was tentatively established, the method of controlling coke diffusion and mass transfer in the later reaction stage was given and related kinetic parameters were corrected, and further improvement of the modified sectioning method was completed.Keywords
Funding Information
- National Natural Science Foundation of China (51974154, 52074150, 51604148)
This publication has 17 references indexed in Scilit:
- A comparison study of existence forms of Fe species in coke for solution loss reaction of carbonJournal of Iron and Steel Research International, 2018
- Microstructure and Phase Transformation of a Sinter Bearing Low Ti During ReductionMetallurgical and Materials Transactions B, 2016
- A modified Arrhenius equation to predict the reaction rate constant of Anyuan pulverized-coal pyrolysis at different heating ratesFuel Processing Technology, 2016
- Reduction and Disintegration Behavior of Sinter under N2–CO–CO2–H2–H2O Gas at 773 KISIJ International, 2015
- Ironmaking Technology for the Last 100 Years: Deployment to Advanced Technologies from Introduction of Technological Know-how, and Evolution to Next-generation ProcessISIJ International, 2015
- Factorial design analysis of reduction of simulated iron ore sinter reduced with CO gas at 1000–1100°CIronmaking & Steelmaking: Processes, Products and Applications, 2014
- Evaluation of Sinter Quality for Improvement in Gas Permeability of Blast FurnaceISIJ International, 2014
- Influence of Mixing Coal Composite Iron Ore Hot Briquettes on Blast Furnace Simulated Reaction Behavior in a Packed Mixed BedISIJ International, 2011
- Characterisation of iron ore sinter and its behaviour during non-isothermal reduction conditionsIronmaking & Steelmaking: Processes, Products and Applications, 2008
- Gaseous Reduction of MgO-doped Fe2O3 Compacts with Carbon-monoxide at 1 173-1 473 K.ISIJ International, 1996