Fatigue crack growth and life prediction of a single interference fitted holed plate
- 16 June 2010
- journal article
- Published by Wiley in Fatigue & Fracture of Engineering Materials & Structures
- Vol. 33 (10) , 633-644
Abstract
To understand the different aspects of fatigue behaviour of complex structural joints it will be much helpful if the effects of different parameters are studied separately. In this article, to study the isolated effect of interference fit on fatigue life a pined hole specimen is investigated. This specimen is a single‐holed plate with an oversized pin which force fitted to the hole. The investigation was carried out both experimentally and numerically. In the experimental part, interference fitted specimens along with open hole specimens were fatigue tested to study the experimental effect of the interference fit. In the numerical part, three‐dimensional finite element (FE) simulations have been performed in order to obtain the created stresses due to interference fit and subsequent applied longitudinal load at the holed plate. The stress distribution obtained from FE simulation around the hole was used to predict crack initiation life using Smith–Watson–Topper method and fatigue crack growth life using the NASGRO equation with applying the AFGROW computer code. The predicted fatigue life obtained from the numerical methods show a good agreement with the experimental fatigue life.Keywords
This publication has 18 references indexed in Scilit:
- Experimental and numerical investigations into the effect of an interference fit on the fatigue life of double shear lap jointsEngineering Failure Analysis, 2009
- Stress-intensity Factors for Two Symmetric Corner Cracks2009
- Experimental and numerical investigation of the effect of clamping force on the fatigue behaviour of bolted platesEngineering Failure Analysis, 2008
- A novel method of cold expansion which creates near‐uniform compressive tangential residual stress around a fastener holeFatigue & Fracture of Engineering Materials & Structures, 2004
- The effect of cold expansion on improving the fatigue life of fastener holesEngineering Failure Analysis, 2003
- Analysis of Widespread Fatigue Damage in Lap JointsSAE International Journal of Advances and Current Practices in Mobility, 1999
- MODELLING RESIDUAL STRESSES AND FATIGUE CRACK GROWTH AT COLD‐EXPANDED FASTENER HOLESFatigue & Fracture of Engineering Materials & Structures, 1991
- Tabulated stress intensity factor solutions for flawed fastener holesEngineering Fracture Mechanics, 1983
- Stress intensity factors for some through-cracked fastener holesInternational Journal of Fracture, 1975
- Some remarks on elastic crack-tip stress fieldsInternational Journal of Solids and Structures, 1972