Investigation on Double Oxide Film Initiated Pore Formation in Aluminum Casting Alloys
Open Access
- 15 April 2020
- journal article
- research article
- Published by University of Debrecen/ Debreceni Egyetem in International Journal of Engineering and Management Sciences
- Vol. 5 (2) , 141-153
Abstract
The most common, and in fact, the most deleterious defects of aluminum casting alloys are the so-called double oxide films or bifilms, which have a central role in porosity formation, as they can easily unfurl and inflate into pores during the solidification of the alloys. Sr addition is generally used in the foundry industry for the modification of the eutectic Si phase of hypoeutectic Al-Si alloys. However, Sr microalloying usually leads to an increased pore formation tendency. As bifilms are preferred sites for pore formation, it should be expected that Sr additions have a significant effect on the number and/or the structure of double oxide films present in the melt. In this work, the relationship between Sr-concentration and the susceptibility to pore formation has been investigated through the evaluation of melt quality of melts which had different levels of Sr. The bifilm content of the melts was investigated by the analysis of K-mold specimens and X-ray computed tomography (CT) of reduced pressure test (RPT) samples. It was found that liquid alloys with a higher Sr concentration had a significantly greater tendency to pore formation, which can be explained by the presence of a larger number of bifilm defects in the liquid alloy.Keywords
This publication has 39 references indexed in Scilit:
- The Myth of Hydrogen Pores in Aluminum Castings2019
- Quantification of Entrainment Damage in A356 Aluminum Alloy CastingsMetallurgical and Materials Transactions A, 2018
- Pore Formation During Solidification of Aluminum: Reconciliation of Experimental Observations, Modeling Assumptions, and Classical Nucleation TheoryMetallurgical and Materials Transactions A, 2017
- Study of Strontium Fading in Al-Si-Mg AND Al-Si-Mg-Cu Alloy by Thermal AnalysisInternational Journal of Metalcasting, 2015
- “Stop Pouring, Start Casting”International Journal of Metalcasting, 2012
- Computer-aided cooling curve thermal analysis used to predict the quality of aluminum alloysJournal of Thermal Analysis and Calorimetry, 2010
- Hydrogen, porosity and oxide film defects in liquid AlJournal of Materials Science, 2009
- The Modification of Al-Si Casting Alloys: Important Practical and Theoretical AspectsInternational Journal of Metalcasting, 2008
- Oxide films, pores and the fatigue lives of cast aluminum alloysMetallurgical and Materials Transactions B, 2006
- Precipitation of Sr-rich intermetallic particles and their influence on pore formation in Sr-modified A356 alloyMetallurgical and Materials Transactions A, 2005