Study of the form function and combustion characteristics of partially‐cut stick propellants
- 7 June 2023
- journal article
- research article
- Published by Wiley in Propellants, Explosives, Pyrotechnics
- Vol. 48 (8)
Abstract
To study the form function and combustion characteristics of partially‐cut stick propellants, this paper derived and established the form function of this complex geometry propellant and analyzed the influence of cutting parameters on the form function. The analysis showed that partially‐cut stick propellants retain the high progressive combustion of multi‐aperture granular propellant, which is proportional to the distance between the notch and inversely proportional to the width of the notch. Based on this, partially‐cut stick propellants with different notches were prepared, and closed vessel tests were conducted. The experimental results showed that the notch had a significant effect on the combustion characteristics of the propellant. When there were notches, the wider the notch, the faster the pressure rise. The pressure in the closed vessel for stick propellants without notches rose the fastest. The burning rate of non‐notched or narrow‐notched fluctuated, while the burning rate of wide‐notched was stable. The dynamic vivacity data showed that the wider the notch, the more stable the change of the burning surface, and the combustion characteristic was closer to the granular propellant. Based on the analysis of form function and combustion characteristics, it is recommended that the notch width be 1 mm and the distance between notches on the same side should be the length of a granular propellant for the double‐base homogeneous 19‐perforated propellant studied in this paper.Keywords
This publication has 19 references indexed in Scilit:
- Research on the Electro-explosive Behaviors and the Ignition Performances of Energetic IgnitersJournal of Energetic Materials, 2017
- Modeling, Simulation and Characterization of Complex Shaped Solid Propellant CombustionPropellants, Explosives, Pyrotechnics, 2017
- Analysis of Pressure Waves Generation in Gun Combustion Chambers During the Propellant Ignition ProcessPropellants, Explosives, Pyrotechnics, 2015
- Emulation and Calculation of the Burning Surface of 3D Grains of Partially Cut Multi‐Perforated Stick Propellant using the Level Set MethodPropellants, Explosives, Pyrotechnics, 2015
- Numerical simulation of impact breakage of gun propellant chargeGranular Matter, 2011
- Three‐Dimensional Simulation of Pressure Fluctuation in a Granular Solid Propellant Chamber within an Ignition StagePropellants, Explosives, Pyrotechnics, 2011
- A new in situ method for the measurement of ignition delays and the propagation of the ignition wave in gun chargesIEEE Transactions on Magnetics, 2003
- Dynamic Vivacity and Its Application to Conventional and Electrothermal-Chemical (ETC) Closed Chamber Results2001
- A New High-Progressivity/High-Density Propulsion Concept: Partially Cut Multiperforated Stick Propellant1991
- Erosive and strand burning of stick propellants. II - Theoretical modeling of erosive-burning processesJournal of Propulsion and Power, 1990