Performance Enhancement of Evacuated Tube Solar Collectors Using Fe3O4 Nanoparticle‐Enhanced Phase Change Materials for Efficient Thermal Energy Storage
Open Access
- 2 July 2025
- journal article
- Published by Wiley in Engineering Reports
- Vol. 7 (7)
Abstract
One of the most efficient solar thermal systems for water heating and thermal energy storage is the evacuated tube solar collectors (ETSC). Glass tubes are vacuum sealed to minimize heat loss while maximizing solar absorption. This study aims to enhance ETSC performance with the use of iron oxide (Fe3O4) nanoparticles infused phase change materials (PCM). The Fe3O4 concentration was varied at three levels: 0.2 wt.%, 0.4 wt.%, and 0.6 wt.%, and they were tested in terms of fluid temperature, heat absorption, thermal efficiency, and exergy efficiency by experimental analysis. The results show that the inclusion of Fe3O4 nanoparticles greatly increases thermal conductivity and thus improves heat transfer and storage. With growth of 0.6 wt.% Fe3O4, the fluid temperature increased from 58.4°C to 94.5°C, and heat absorption increased from 2516.9 W to 3804.1 W, increasing thermal efficiency from 46.1% to 83.5% and exergy efficiency from 31.2% to 45.2%. To decrease the irreversibility, energy efficiency was improved. The proposed system exhibited enhanced thermal diffusivity, reduced subcooling, and micro‐convective currents due to the addition of Fe3O4 nanoparticles. The potential use of Fe3O4 based Ne‐PCM was experimentally verified, suggested as a sustainable, energy‐efficient thermal storage material for solar thermal applications.Keywords
This publication has 39 references indexed in Scilit:
- Modeling of Heat Transfer and Airflow Inside Evacuated Tube Collector With Heat Storage Media: Experimental Validation Powered by Artificial Neural NetworkHeat Transfer, 2024
- Performance enhancement of evacuated U-tube solar collector integrated with phase change materialCase Studies in Thermal Engineering, 2024
- Differential exergy investigation and environ-economic assessment of a dimpled plate and flat plate solar air heater under turbulent conditionsApplied Thermal Engineering, 2023
- Preparation and control mechanism of nano-phase change emulsion with high thermal conductivity and low supercooling for thermal energy storageEnergy Reports, 2022
- A critical review on phase change materials (PCM) for sustainable and energy efficient building: Design, characteristic, performance and applicationEnergy and Buildings, 2022
- Melting and solidification processes of phase change material in evacuated tube solar collector with U-shaped spirally corrugated tubeApplied Thermal Engineering, 2021
- Experimental investigation of an evacuated tube solar collector incorporating nano-enhanced PCM as a thermal boosterApplied Thermal Engineering, 2020
- An up-to-date review on evacuated tube solar collectorsJournal of Thermal Analysis and Calorimetry, 2020
- Geometry and nanoparticle loading effects on the bio-based nano-PCM filled cylindrical thermal energy storage systemApplied Thermal Engineering, 2018
- Nano-PCMs for enhanced energy storage and passive cooling applicationsApplied Thermal Engineering, 2017