A Proposed Technique to Acquire Cavity Pressure Using a Surface Strain Sensor During Injection-Compression Molding
Authors:
- Wei-Sheng GuanWGWei-Sheng Guan
- Han-Xiong HuangHHHan-Xiong Huang
- 22 March 2013
- journal article
- research article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 135 (2) , 021003
Abstract
A new technique was proposed and experimentally verified for the cavity pressure acquisition in the injection-compression molding (ICM). The surface strain of the fixed mold half and the cavity pressure were monitored simultaneously during ICM. In the compression stage, a directly proportional relationship between the cavity pressure and mold surface strain was found and determined via the regression analysis. By taking the advantage of this relationship, the cavity pressure profile with high accuracy was indirectly obtained from the nondestructive measurement of the mold surface strain. Moreover, the mold surface strain profile could indicate the part weight or thickness and the critical time when the part surface lost contact with the cavity surface in a large area. The monitoring of the mold surface strain could serve as an interesting alternative to the direct monitoring of the cavity pressure with respect to process and part quality control for ICM.Keywords
This publication has 19 references indexed in Scilit:
- Multivariate sensing and wireless data communication for process monitoring in RF-shielded environmentCIRP Annals, 2012
- Process Factors Influence on Cavity Pressure Behavior in Microinjection MouldingJournal of Manufacturing Science and Engineering, 2011
- A comparison of seven filling to packing switchover methods for injection moldingPolymer Engineering & Science, 2010
- Investigation of fiber orientation states in injection‐compression molded short‐fiber‐reinforced thermoplasticsPolymer Composites, 2010
- Cavity pressure control during cooling in plastic injection moldingAdvances in Polymer Technology, 2006
- A review of current developments in process and quality control for injection moldingAdvances in Polymer Technology, 2005
- Numerical prediction of residual stresses and birefringence in injection/compression molded center‐gated disk. Part II: Effects of processing conditionsPolymer Engineering & Science, 2002
- Simulation of injection‐compression molding process, Part 3: Effect of process conditions on part birefringenceAdvances in Polymer Technology, 2002
- Control of part weight in injection molding of amorphous thermoplasticsPolymer Engineering & Science, 1999
- Online pattern‐based part quality monitoring of the injection molding processPolymer Engineering & Science, 1996