Process Factors Influence on Cavity Pressure Behavior in Microinjection Moulding
- 1 June 2011
- journal article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 133 (3) , 031007
Abstract
Process monitoring of microinjection moulding (μIM) is of crucial importance when analysing the effect of different parameter settings on the process and then in assessing its quality. Quality factors related to cavity pressure can provide valuable information about the process dynamics and also about the filling behavior of different polymer melts. In this paper, a pressure sensor mounted inside a tool cavity was employed to analyse maximum cavity pressure, pressure increase rate during filling and pressure work. The influence of four μIM parameters, melt temperature, mould temperature, injection speed, and packing pressure on these three pressure-related process parameters was investigated. A design of experiment study was conducted by moulding a test part, a microfluidic component, in three different polymer materials, PP, ABS, and PC. The results show a similar process behavior for all three polymers, in particular a higher injection speed led to a reduction of the pressure work while a lower mould temperature reduces the pressure rate.Keywords
This publication has 21 references indexed in Scilit:
- Experimental investigation of plastic injection molding: Assessment of the effects of cavity pressure and mold temperature on the quality of the final productsMaterials & Design (1980-2015), 2009
- A study of the effects of process parameters for injection molding on surface quality of optical lensesJournal of Materials Processing Technology, 2009
- The finite element analysis of melt flow behaviour in micro-injection mouldingProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2008
- Cavity pressure based grey prediction of the filling-to-packing switchover point for injection moldingJournal of Materials Processing Technology, 2007
- Method for generation of rheological model to characterize non-conventional injection molding by means of spiral moldJournal of Materials Processing Technology, 2005
- Design of experiment considering two-way interactions and its application to injection molding processes with numerical analysisJournal of Materials Processing Technology, 2004
- Implementation and analysis of polymeric microstructure replication by micro injection moldingJournal of Micromechanics and Microengineering, 2003
- Micro EngineeringCIRP Annals, 2003
- Monitoring cavity pressure perfects injection moldingAssembly Automation, 1999
- Thermoviscoelastic simulation of thermally and pressure-induced stresses in injection moulding for the prediction of shrinkage and warpage for fibre-reinforced thermoplasticsJournal of Non-Newtonian Fluid Mechanics, 1999