Measurement method for radial runout of sprocket based on machine vision
Open Access
- 1 October 2025
- journal article
- Published by IOP Publishing in Engineering Research Express
- Vol. 7 (4) , 045503
Abstract
Due to the structural constraints of sprockets and the efficiency requirements of on-site measurements, conventional external parameter calibration methods are difficult to apply to the calibration of the sprocket hub end surface. Therefore, this paper proposes a novel external parameter calibration method based on the invariance of quadratic curves. A cylindrical object with concentric circular rings is inserted into the central hole of the sprocket, and the radii of the large and small circles on the rings, along with the radius of the sprocket hub hole, are used to derive the coefficients of the equations corresponding to the three circles. Based on these coefficients, the external parameters of the sprocket hub end surface are determined. According to the contour characteristics of the sprocket teeth, a point selection model is established to identify the highest and lowest points within the tip and root circle regions. The radial runout is then calculated as the difference in radial distances between the highest and lowest points. In the experiments, eleven sprockets of different sizes were selected as test objects, and the results obtained using the proposed method were compared with those measured by a coordinate measuring machine (CMM). The results indicate that the measurement error of the tooth root and tip circles is less than 42 μm.Keywords
This publication has 22 references indexed in Scilit:
- Evaluation and prediction of drilling wear based on machine visionThe International Journal of Advanced Manufacturing Technology, 2021
- Design of high accuracy cylindrical profile measurement model for low-pressure turbine shaft of aero engineAerospace Science and Technology, 2019
- A machine vision algorithm for quality control inspection of gearsThe International Journal of Advanced Manufacturing Technology, 2019
- A new fault diagnosis method for planetary gear based on image feature extraction and bag-of-words modelMeasurement, 2019
- Camera based precision measurement in improving measurement accuracyMeasurement, 2014
- External parameter calibration of widely distributed vision sensors with non-overlapping fields of viewOptics and Lasers in Engineering, 2013
- Computer vision algorithms for measurement and inspection of spur gearsMeasurement, 2011
- Novel calibration method for non-overlapping multiple vision sensors based on 1D targetOptics and Lasers in Engineering, 2011
- A global calibration method for large-scale multi-sensor visual measurement systemsSensors and Actuators A: Physical, 2004
- Self-Calibration of Stationary CamerasInternational Journal of Computer Vision, 1997