A Shape‐Morphing Ceramic Composite for Variable Geometry Scramjet Inlets
Authors:
- 3 May 2011
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 94 (s1) , s35-s41
Abstract
The development of ceramic composites with three‐dimensional fiber reinforcement architectures formed by textile methods has led to the potential for active shape‐morphing surfaces that can operate in high temperature and variable pressure environments. This technology is of particular interest for hypersonic applications, where SCRAM jet engines require variable inlet geometry to achieve efficient flight over realistic flight profiles and variable flight conditions. The experiments reported here show that significant shape morphing can be achieved and good control of the shape sustained even in the presence of large temperature and pressure gradients. Experiments were carried out using a subscale morphing hypersonic inlet with rectangular cross‐section in a Mach 8 wind tunnel facility with a total temperature of 800 K. The upper surface of the inlet consisted of a C–SiC composite plate (0.7 mm thick, 37.5 cm long, and 11 cm wide) connected to five actuators through a triangular truss support structure. The lower surface was a flat plate instrumented with an array of pressure taps along the flow centerline. As the shape varied, the surface contour was reliably controlled for high efficiency, low loss compression. A factor of six inlet area ratio variation was achieved and good agreement with model predictions was observed.Keywords
This publication has 14 references indexed in Scilit:
- Treating matrix nonlinearity in the binary model formulation for 3D ceramic composite structuresComposites Part A: Applied Science and Manufacturing, 2010
- Integral Textile Ceramic StructuresAnnual Review of Materials Research, 2008
- Twisting of a high authority morphing structureInternational Journal of Solids and Structures, 2007
- Design and demonstration of a high authority shape morphing structureInternational Journal of Solids and Structures, 2004
- The Load Capacity of a Kagome Based High Authority Shape Morphing StructureJournal of Applied Mechanics, 2004
- Kagome plate structures for actuationInternational Journal of Solids and Structures, 2003
- Optimal design of a flexural actuatorJournal of the Mechanics and Physics of Solids, 2001
- Collapse of truss core sandwich beams in 3-point bendingInternational Journal of Solids and Structures, 2001
- Influence of Loading Frequency on the Room‐Temperature Fatigue of a Carbon‐Fiber/SiC‐Matrix CompositeJournal of the American Ceramic Society, 1993
- Influence of Stress Ratio on the Elevated‐Temperature Fatigue of a Silicon Carbide Fiber‐Reinforced Silicon Nitride CompositeJournal of the American Ceramic Society, 1991