Shock-Resistibility of MEMS-Based Inertial Microswitch under Reverse Directional Ultra-High g Acceleration for IoT Applications
Open Access
- 31 March 2017
- journal article
- research article
- Published by Springer Nature in Scientific Reports
- Vol. 7 (1) , 45512
Abstract
This paper presents a novel MEMS-based inertial microswitch design with multi-directional compact constraint structures for improving the shock-resistibility. Its shock-resistibility in the reverse-sensitive direction to ultra-high g acceleration (~hunderds of thousands) is simulated and analyzed. The dynamic response process indicates that in the designed inertial microswitch the proof mass weight G, the whole system’s stiffness k and the gap x2 between the proof mass and reverse constraint blocks have significant effect on the shock-resistibility. The MEMS inertial microswitch micro-fabricated by surface micromachining has been evaluated using the drop hammer test. The maximum allowable reverse acceleration, which does not cause the spurious trigger, is defined as the reverse acceleration threshold (athr). Test results show that athr increases with the decrease of the gap x2, and the proposed microswitch tends to have a better shock-resistibility under smaller gap. The measured responses of the microswitches with and without constraint structure indicates that the device without constraint structure is prone to spurious trigger, while the designed constraint structures can effectively improve the shock-resistibility. In this paper, the method for improving the shock-resistibility and reducing the spurious trigger has been discussed.Keywords
This publication has 14 references indexed in Scilit:
- Design and fabrication of a laterally-driven inertial micro-switch with multi-directional constraint structures for lowering off-axis sensitivityJournal of Micromechanics and Microengineering, 2016
- Ultra low actuation voltage RF MEMS switchMicro and Nano Systems Letters, 2015
- Chipless RFID tag using RF MEMS switchElectronics Letters, 2014
- Influence of applied acceleration loads on contact time and threshold in an inertial microswitch with flexible contact-enhanced structureSensors and Actuators A: Physical, 2014
- The design, simulation and fabrication of a novel horizontal sensitive inertial micro-switch with lowgvalue based on MEMS micromachining technologyJournal of Micromechanics and Microengineering, 2013
- A directly strain measuring method for electroplated nickel micro-tensile testMicrosystem Technologies, 2010
- Design, simulation and fabrication of a novel contact-enhanced MEMS inertial switch with a movable contact pointJournal of Micromechanics and Microengineering, 2008
- Design and characterization of inertia-activated electrical micro-switches fabricated and packaged using low-temperature photoresist molded metal-electroplating technologyJournal of Micromechanics and Microengineering, 2003
- Acceleration switch with extended holding time using squeeze film effect for side airbag systemsSensors and Actuators A: Physical, 2002
- Airbag application: a microsystem including a silicon capacitive accelerometer, CMOS switched capacitor electronics and true self-test capabilitySensors and Actuators A: Physical, 1995