A study on dynamic pressure sensor based on Pitot tube structure
Open Access
- 1 March 2024
- journal article
- research article
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 95 (3)
Abstract
To meet the demand for the accurate measurements of the dynamic pressure of a shock wave, a composite dynamic pressure sensor design method is proposed based on the formation mechanism, propagation characteristics, special testing environment of the dynamic pressure, and Pitot tube structure. The dynamic pressure of the shock wave is evaluated by the total pressure and static pressure units installed in the composite sensor. FLUENT simulation software was used to analyze the aerodynamic characteristics of the dynamic pressure sensor, and parameters such as the structural size and inlet position of the sensor were determined. In response to the special experimental environment of the shock wave, the requirements for the dynamic pressure measurements under damage conditions were analyzed, and a dynamic pressure testing system was established. Dynamic pressure tests with four 2,4,6-trinitrotoluene [C7H5(NO2)3] equivalents of 1, 2, 15, and 20 kg were carried out. The experimental results show that the proposed sensor design method can accurately and effectively measure the dynamic pressure signal, and the dynamic pressure gain multiple decreases with an increase in the proportional distance. This provides an effective testing method for evaluating the dynamic pressure damage effect of ammunition systems.Keywords
Funding Information
- National Natural Science Foundation of China (12102050)
This publication has 24 references indexed in Scilit:
- Study on the characteristics of blast loads due to two simultaneous detonated charges in real airInternational Journal of Non-Linear Mechanics, 2022
- Numerical simulations of trajectories of shock wave triple points in near-ground explosions of TNT chargesEnergetic Materials Frontiers, 2022
- Modeling of the whole process of shock wave overpressure of free-field air explosionDefence Technology, 2019
- Blast response of beams built with high-strength concrete and high-strength ASTM A1035 barsInternational Journal of Impact Engineering, 2019
- Evaluation of the existing triple point path models with new experimental data: proposal of an original empirical formulationShock Waves, 2017
- Modeling blast waves, gas and particles dispersion in urban and hilly ground areasJournal of Hazardous Materials, 2014
- Experimental investigation on characteristics of blast load in partially confined cabin structureJournal of Shanghai Jiaotong University (Science), 2013
- Analysis of reflected blast wave pressure profiles in a confined roomShock Waves, 2012
- Blast characteristics and TNT equivalence values for some commercial explosives detonated at ground levelJournal of Hazardous Materials, 1996
- Blast measurements and equivalency for spherical charges at small scaled distancesInternational Journal of Impact Engineering, 1986