Investigation of a cleaning procedure for silicon spheres used in the realization and dissemination of the redefined kilogram via combined spectroscopic and gravimetric measurements
Open Access
- 11 December 2020
- journal article
- research article
- Published by EDP Sciences in International Journal of Metrology and Quality Engineering
- Vol. 11, 18
Abstract
The new definition of the SI kilogram requires new methods of realizing this unit. The X-ray crystal density method is a primary realization method and uses silicon spheres. The spheres get cleaned before each measurement, in order to remove surface contaminations and thus reduce their uncertainty contribution to the realization. Therefore, cleaning is an inherent part of the realization and dissemination of the kilogram. A cleaning method for silicon spheres is investigated, concerning its suitability as a part of the realization of the redefined kilogram. Six silicon spheres were used to determine the repeatability of the established cleaning method. Measurements of the spheres' mass and the quantification of their surface layer mass after cleaning were carried out in several cycles resulting in 29 mass and surface measurements. The repeatability of the cleaning method applied shows a standard deviation in the order of two micrograms for both the mass and the surface layer. The cleaning method therefore sufficiently fulfils these requirements.Keywords
This publication has 15 references indexed in Scilit:
- Improved measurement results for the Avogadro constant using a28Si-enriched crystalMetrologia, 2015
- Characterization of High-k Nanolayers by Grazing Incidence X-ray SpectrometryMaterials, 2014
- State-of-the-art mass determination of28Si spheres for the Avogadro projectMetrologia, 2011
- Reference-free X-ray spectrometry based on metrology using synchrotron radiationJournal of Analytical Atomic Spectrometry, 2008
- Absolute determination of cross sections for resonant Raman scattering on siliconPhysical Review A, 2006
- Improved accuracy of quantitative XPS analysis using predetermined spectrometer transmission functions with UNIFIT 2004Surface and Interface Analysis, 2005
- Thickness determination for Cu and Ni nanolayers: Comparison of completely reference-free fundamental parameter-based X-ray fluorescence analysis and X-ray reflectometrySpectrochimica Acta Part B: Atomic Spectroscopy, 2005
- Ultrathin SiO2 on Si. I. Quantifying and removing carbonaceous contaminationJournal of Vacuum Science & Technology A, 2003
- Calculations of electron inelastic mean free paths (IMFPS). IV. Evaluation of calculated IMFPs and of the predictive IMFP formula TPP‐2 for electron energies between 50 and 2000 eVSurface and Interface Analysis, 1993
- Hartree-Slater subshell photoionization cross-sections at 1254 and 1487 eVJournal of Electron Spectroscopy and Related Phenomena, 1976