Three-Point Technique for Partial Discharge Location on XLPE Armoured Underground Cable
- 21 September 2015
- journal article
- Published by Trans Tech Publications, Ltd. in Applied Mechanics and Materials
- Vol. 793, 119-123
Abstract
Recently, a new partial discharge location technique called three-point technique had been introduced to locate partial discharge on underground cable. It is the improvement of double-end technique. In this paper, the mathematical formula of three-point technique had been simplified from previous research. Alternative Transient Program (ATP) was being used to simulate both double-end and three-point technique. The results of the simulation were compared and analysed based on the accuracy, cost of implementation and algorithm complexity of the technique. Three-point technique had shown significant improvement in the accuracy of partial discharge location on underground cable.Keywords
This publication has 6 references indexed in Scilit:
- Partial discharge location in power cables using a double ended method based on time triggering with GPSIEEE Transactions on Dielectrics and Electrical Insulation, 2013
- Partial discharge pulse propagation, localisation and measurements in medium voltage power cables2013
- Parameters Identification and Modeling of High-Frequency Current Transducer for Partial Discharge MeasurementsIEEE Sensors Journal, 2012
- Modeling and experimental verification of on-line PD detection in MV covered-conductor overhead networksIEEE Transactions on Dielectrics and Electrical Insulation, 2010
- On-line PD measuring system modeling and experimental verification for covered-conductor overhead distribution lines2007
- An overview of integratable current sensor technologies2004